I,_ |
| ARNING: | TO AVOID | SERIOUS INJURY, BEFORE | PERFORMING | ANY SER- | ||||||
| VICE OR ADJUSTMENTS: |
|
|
|
|
|
| |||||
| 1. | Depress | clutch/brake | pedal fully and | set parking | brake. |
|
| ||||
| 2. | Place | motion control | lever | in neutral | (N) position. |
|
|
| |||
| 3. | Place | attachment | clutch in "DISENGAGED" | position. |
|
| |||||
| 4. | Turn | ignition key to "STOP" | and remove key. |
|
|
| |||||
| 5. | Make sure the blades and | all moving | parts | have completely | stopped. | ||||||
| 6. | Disconnect spark | plug wire | from spark plug and place wire | where | it cannot | ||||||
|
| come in contact with plug. |
|
|
|
|
|
| ||||
TRACTOR
TO REMOVE MOWER
Mower will be easier to remove from the right side of tractor.
1.Place attachment clutch in "DISEN- GAGED" position.
2.Move attachment lift lever forward to lower mower to its lowest position.
3.Roll belt off engine pulley.
4.Remove small retainer spring, and remove clutch spring off pulley bolt.
5.Remove large retainer spring, slide
collar off and push housing guide out of bracket.
6.Disconnect
7.Disconnect suspension arms from rear deck brackets by removing retainer springs.
8.Disconnect front links from deck by removing retainer springs.
9.Raise lift lever to raise suspension arms. Slide mower out from under trac- tor.
IMPORTANT: If an attachment other than the mower deck is to be mounted on the tractor, remove the front links and hook
the clutch spring Into square hole in frame.
TO INSTALL MOWER
1.Raise attachment lift lever to its highest position.
2.Slide mower under tractor with deflec- tor shield to right side of tractor.
3.Lower lift lever to its lowest position.
4.Connect front links to mower deck and secure with retainer springs.
5.Connect suspension arms to rear deck brackets and secure with retainer
springs.
6.Connect
spring.
7.Push clutch cable housing guide into bracket, slide collar onto guide and secure with large retainer spring.
8.Place flat washer and clutch spring on idler pulley bolt and secure with small retainer spring.
9.Install belt onto engine pulley.
Clutch Spring
Small Retainer Spring
Retainer Spring
| Retainer Springs |
Collar ._. | (Both Sides) |
| Deflector Shield |
Large
HousingRetainer
Spring Bracket
22