Craftsman 917.27316 owner manual Battery, Fuel System, Engine OIL, Cylinders

Page 28

Immediately prepare your tractor for stor- age at the end of the season or if the trac-

_ will not be used for 30 days or more. WARNING: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected

and battery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in

the Maintenance section of this manual).

After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage.

Also, alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio

found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car-

buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable pro- tective cover that does not retain mois-

ture. Do not use plastic. Plastic cannot breathe which allows condensation to

form and will cause your tractor to rust. IMPORTANT: Never cover tractor while

engine and exhaust areas are still warm.

28

Image 28
Contents IC..FTSMeWl Limited Warranty on Craftsman Riding Equipment Limited Warranty on BatteryGeneral Operation II. Slope OperationDo not IV. ServiceIII. Children Across Sears Installation Service Product SpecificationsCustomer Responsibilities Steer HOW to SET UP Your Tractor Tools Required for AssemblyInstall Seat To Remove Tractor fromCheck Battery Install Mulcher Plate Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts@@@@ Know Your Tractor Throttle/Choke Attachment Control Lift LeverHOW to USE YOU R Tractor To SET Parking BrakeGround Drive EngineTo Adjust Gauge Wheels To Stop Mower BladesTo Operate on Hills To TransportBefore Starting the Engine Towing Carts and Other Attach MentsADD Gasoline To Start EngineAutomatictransmissionwarm UP Purge TransmissionMowing Tips Mulching Mowing TipsLubrication Chart Maintenance ScheduleGeneral Recommendations Before Each USEBattery TractorOperator Presence System Blade RemovalEngine Transaxle Pump FluidBelts LubricationClean AIR INTAKE/COOLING Areas Clean AIR ScreenCleaning MufflerTo Install Mower To Remove MowerTo Level Mower Housing Belt InstallationBelt Removal To Replace Mower Blade Drive BeltTo Check and Adjust Brake To Replace Motion Drive BeltTransmission Removal Replacement To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery Front Wheel TOE-IN/CAMBERReplacing Battery To Remove Hood and Grill AS- SemblyTo Adjustthrottle Control Cable To Adjust CarburetorBattery Fuel SystemEngine OIL CylindersTroubleshooting Chart CorrectionClean Problem CauseProblem Cause Correction OFFPage Tractor - Model Number Schematic RedlackTractor - Model Number Electrical KEY Part Description Tractor - Model Number 917.273160 Chassis and Enclosures Stlt Tractor - Model Number Ground Drive 25/32 Tractor - Model Number 917.273160 Steering Assembly KEY Part NO, NO,DESCRIPTION Optional Equipment Tractor - Model Number EngineNO. NO.DESCRIPTION Tractor - Model Number Seat Assembly KEY Part DescriptionTractor - Model Number Decals Wheels TiresTractor - Model Number Lift Assembly 2020Tractor - Model Number Mower Deck Tractor - Model Number Mowerdeck 128 109 900 127 124 125 Rotor, Brake Cylinder HEAD, Valve and Breather Cylinder HEAD/VALVE/BREATHER Blower Housing and Bafflesi IGNITION/ELECTRICAL Blower Housing & BafflesNotillustrated OIL PAN / LU Brcation Kohler ENGINE-MODEL Number CV492,TYPE Number Tractor - Model NumberKEY Part Fuelsystem Fuel System Exhaust KEY Part DescriptionPage Suggested Guide for Sighting Slopes for Safe Operation 6E/ARS