Fluke Rev. 4 Communicating with a PC Model 702 Only, Maintenance, Replacing the Battery Pack

Documenting Process Calibrator Communicating with a PC (Model 702 Only)

Communicating with a PC (Model 702 Only)

You can upload and download procedures and saved results to a PC. An IBM PCTM-compatible personal computer, Microsoft Windows 3.1, and Fluke PMLink software are required. A custom serial interface cable for the 702 is included with PMLink. Refer to the PMLink Manual for further instructions.

Maintenance

NOTE

Additional maintenance instructions including a calibration procedure, full parts list, and schematic diagrams are available in the 701/702 Service Manual, PN 944525.

Replacing the Battery Pack

Replace the battery pack when it no longer holds a charge for the rated interval. The battery normally lasts for up to 1000 charge/discharge cycles. To order a replacement battery, order Model BP7217 Nickel-Cadmium Battery Pack. In the USA and

Canada call Fluke Service Parts at (800) 526-4731. Outside the USA and Canada call +1 206-356-5500 to receive instructions.

NDo not mix spent Nickel-Cadmium batteries with the solid waste stream. Spent batteries should be disposed of by a qualified recycler or hazardous materials handler. Contact your authorized Fluke Service Center for recycling information.

Internal Lithium Backup Battery

A lithium battery maintains the memory contents and

ssettings. The normal sevice life for the lithium battery is 3 to 5 years.

You cannot access the lithium battery. Return the calibrator to an authorized Fluke service center listed at the back of the manual if you need to replace the lithium battery. When the lithium battery is 3 years old, replace it at the next calibration interval as a preventive maintenance procedure.

Cleaning the Calibrator

Clean the calibrator and pressure modules with a soft cloth dampened with water or water and mild soap.

83