Fluke Rev. 4 user manual 701/702, If necessary, press Mfor SOURCE mode

701/702

Users Manual

To avoid damaging the pressure module from corrosion, use them only with specified materials. Refer to the pressure module instruction sheet for the specified material compatibility for your pressure module.

1.Connect a pressure module and pressure source to the calibrator as Figure 17 shows. The threads on the pressure modules accept ¼ NPT fittings.

Use the supplied ¼ NPT to ¼ ISO adapter if necessary.

2.If necessary, press Mfor SOURCE mode.

3.Press p. The calibrator automatically senses which pressure module is attached and sets its range accordingly.

4.To zero the pressure module, vent the module to atmosphere, and press c. Repeat this step until the reading is zeroed. You must perform this step before you execute a PMLink Task that sources pressure

5.Pressurize the pressure line with the pressure source to the desired level as shown on the display.

6.If necessary, you can change pressure display

units to psi, mmHg, inHg, inH2O, ftH2O, bar, or kPa as follows:

a.Press s

b.Press Next Page twice.

c.Press ewith the cursor on Pressure Units.

d.Select the pressure units with the uor d keys.

e.Press e.

f.Press the Done softkey.

48