Fluke Rev. 4 Observing Min and Max Measurements, Viewing the Task List Model 702 Only, 701/702

701/702

Users Manual

9.Press the Done softkey. The display changes to the following:

10.Note the LOG annunciator next to MEASURE. Press the Start Logging softkey to start taking data.

11.The calibrator will continue storing data points until the duration has elapsed, or until you press the Stop Logging softkey. Either way of terminating logging causes the calibrator to save the data as a memory item that can be uploaded to a PC with PMLink software.

Observing Min and Max Measurements

You can set the display to record and show the maximum and minimum readings. Min and Max readings are always undamped, even if Dampen is On. Press the More Choices softkey twice, then press the Min Max softkey to turn on this feature. Press the ckey to reset the Min Max registers. Press the Min Max softkey again to revert to the normal display. The following figure shows the display with Min Max on:

Viewing the Task List (Model 702 Only)

Press the More Choices softkey until the Tasks softkey appear, then press More Choices to view

72