Documenting Process Calibrator
Introduction | Thermocouple (TC) input/output jack that is | |
Fluke 701 and 702 Documenting Process Calibrators | connected to an internal isothermal block with | |
automatic | ||
(hereafter referred to as the calibrator) are battery- | ||
compensation. Or, you can manually enter an | ||
powered, | ||
external temperature reference. | ||
source electrical and physical parameters. See Table | ||
| ||
1. The calibrator lets you troubleshoot, calibrate, | Stores results for later review. | |
verify, and document the calibration of process | Logs up to 8,000 data points (Model 702 with | |
instruments. See the back of this manual for | ||
PMLink software only.) | ||
complete specifications. | ||
| ||
In addition to the functions in Table 1, the 701 and | PC interface for uploading/downloading | |
procedures, lists, and results using PMLink | ||
702 calibrators have the following features: | ||
software (Model 702 only). | ||
∙ General features: | ||
Automatic calibration procedures for transmitters | ||
| ||
Analog display in measurement mode to make it | using split screen MEASURE/SOURCE mode. | |
easy to read the input level when the input is | Once you select the test parameters, you can | |
unstable. | select an automatic procedure or you can | |
Display shows information in English, French, | execute the test points one at a time. | |
∙ Features available in MEASURE mode: | ||
German, Italian, or Spanish. |
1