701/702

Users Manual

Auto Backlight Off is activated, the asymbol shows at the top of the display. To automatically turn off the backlight after a set time, proceed as follows:

1.Press s.

2.Press d to highlight Off following Auto Backlight Off.

3.Press eor the Choices softkey.

4.Press u to highlight On, then press e.

5.To accept the timeout period shown on the display, you can finish here. Press Done to exit s mode and do not go on to step 6.

6.To change the timeout period, press d to highlight the timeout period following Backlight Timeout.

7.Press eor the Choices softkey.

8.Enter your choice of timeout period in minutes (accepted range: 1 to 120 minutes).

9.Press the Done softkey.

10.Press the Done softkey or sto exit s mode.

Personalizing the Calibrator

You can load your name or some another alphanumeric identifier into the calibrator for display at power-up and in saved results. Proceed as follows to load an identifier:

1.Press s

2.Press Next Page twice.

3.Press dto move the cursor to the same line as ID.

4.Press eor the Choices softkey. The display appears as follows:

26

Page 36
Image 36
Fluke Rev. 4 user manual Personalizing the Calibrator