Fluke Rev. 4 user manual Simulating RTDs, 701/702

701/702

Users Manual

Simulating RTDs

NOTE

Refer to Table 6 for information about RTD (Resistance Temperature Detector) types supported by the calibrator.

Connect the calibrator to the instrument under test as shown in Figure 19. Proceed as follows to simulate an RTD (Resistance Temperature Detector):

1.If necessary, press Mfor SOURCE mode.

2.Press tuntil the select RTD type display is showing.

3.Press the uor dkeys followed by eto select the desired RTD type.

4.Enter the temperature you want to simulate as prompted by the display, then press e.

52