Craftsman 917.37248 owner manual Other, Handle See Fig, Fuel System, Engine OiL, Cylinder

Page 17

STORAGE

Immediately prepare your lawn mower for storage at the

end of the season or if the unit wilt not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

,Clean entire lawn mower (See "CLEANING" in the Customer Responsibilities section of this manual).

,Lubricate as shown in the Customer Responsibilities section of this manual.

Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

Touch up all rusted or chipped paint surfaces; sand lightly before painting.

HANDLE (See Fig. 21)

You can fold your lawn mower handle for storage.

Squeeze the bottom ends of the lower handle toward each other until the lower handle clears the handle bracket, then move handle forward.

Loosen upper handle mounting bolts enough to allow upper handle to be folded back.

IMPORTANT: WHEN FOLDING THE HANDLE FOR

STORAGE OR TRANSPORTATION, BE SURE TO FOLD

THE HANDLE AS SHOWN OR YOU MAY DAMAGE THE CONTROL CABLES.

When setting up your hand!e from the storage position, the lower handle will automatically lock into the mow- ing position.

LOWER HANDLE

HANDLE

BRACKET

HAIRPIN

COTTER

OPERATOR PRESENCE

CONTROLBAR

UPPER HANDLE

FOLDFORWARD

FORSTORAGE

FOLD BACKWARD

MOWING

POSITION

LOWER HANDLE

FiG. 21

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL

SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER,

FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED

FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

Drain the fue! tank.

Start the engine and let it run until the fuel lines and carburetor are empty.

,Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer

container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do

not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OiL

Drain oii (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Customer Responsibilities section of this manual).

CYLINDER

Remove spark plug.

Pour one ounce (29 m!) of oil through spark plug hole into cylinder.

Pull starter handle slowly a few times to distribute oil. , Replace with new spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

tf possible, store your unit indoors and cover it to give protection from dust and dirt.

Cover your unit with a suitable protective cover that

does not retain moisture. Do not use plastic. Plastic cannot breathe which al!ows condensation to form and

will cause your unit to rust.

IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

CAUTION: Never store the lawn mower with gasoline in the tank inside a build- ing where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

17

Image 17
Contents Sears Training Maintenance AndstoragePreparation OperationProduct Specifications Limited TWO Year Warranty on Craftsman Power MowerIndex Rear BAG Optional EngineLawn Mower Performance To Remove Lawn Mower from Carton HOW to SET UP Your LawnMower Lowerhandle CatcherframeKnow Your Lawn Mower OperationTo Install Grass Catcher See Fig HOW to USE Your Lawn MowerEngine Speed See Fig Engine Zone ControlOperatorpresence Controlbar Drivecontr To Adjust Cutting Height See FigPour OIL SLOWLY. do not Over Fill To Start EngineMowing Tips OP AtionGeneral Recommendations Maintenance ScheduleAS YOU Complete Before Each USELawn Mower Clean Under Drive Cover CleaningAIR Filter Spark PlugTo Adjust Drrve Control Cable To Adjust Cutting HeightLawn Mower Discharge GuardCarburetor To Adjust Handle See Figs, 18 ThruEngine Speed Handle See Fig OtherFuel System Engine OiL0RAFTSMAN 22 Rotary Lawn Mower Model Number Repair PartsKEY Part Description Craftsman 22 Rotary Lawn Mower Model NumberRaftsman 22 Rotarylawn Mower Model Number Description KEY PartPart Description Gear Case Assembly Part Number KEY PartKEY Craftsman 4-CYCLE Engine REF Part NO. no Description REF Part NO, noREF Part Rewind Starter noREF Part NO. no Service Notes Cause Correction Troubleshooting PointsEngine Craftsman Model no Part Number Part Description Iiii