Craftsman 917.270732 owner manual Stopping, HOW to USE Your Tractor

The operation of any tractor the eyes, which can result in glasses or eye shields while adjustments or repairs. We over spectacles or standard

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

•Depress clutch/brake pedal into full "BRAKE" position and hold.

•Place parking brake lever in "EN- GAGED" position and release pres- sure from clutch/brake pedal. Pedal

should remain in "BRAKE" position. Make sure parking brake will hold

tractor	secure.
Attachment Clutch Lever Ignition Key
"Enc	"Disengaged"
Position	Position
Throttle/	Brake
Choke	ed"
	Position

can result in foreign objects thrown into severe eye damage. Always wear safety operating your tractor or performing any recommend a wide vision safety mask safety glasses.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas.

A CAUTION: Always stop tractor completely, as described above, before leaving the operator's position; to empty grass catcher, etc.

TO USE THROTTLE CONTROL

Always operate engine at full throttle.

•Operating engine at less than full throttle reduces the battery charging rate.

•Full throttle offers the best bagging and mower performance.

TO MOVE FORWARD AND

BACKWARD

The direction and speed of movement is

Clutch/Gearshift

	Brake"
"Disengaged" Position	Position

STOPPING

MOWER BLADES -

•To stop mower blades,move attach- ment clutch lever to "DISENGAGED"

position.

GROUND DRIVE -

•To stop ground drive, depress clutch/ brake pedal into full "BRAKE" position.

•Move gearshift lever to neutral (N) position.

ENGINE -

•Move throttle control to slow position.

NOTE: Failure to move throttle control to

slow position and allowing engine to idle before stopping may cause engine to "backfire".

•Turn ignition key to "OFF" position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

•Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch in any position other than "OFF" will cause the battery to be discharged, (dead).

controlled by the gearshift lever.

•Start tractor with clutch/brake pedal depressed and gearshift lever in neutral (N) position.

•Move gearshift lever to desired position.

•Slowly release clutch/brake pedal to start movement.

IMPORTANT: Bring tractor to a complete stop before shifting or changing gears. Failure to do so will shorten the useful

life of your transaxle.

TO ADJUST MOWER CUTTING HEIGHT

The position of the attachment lift lever determines the cutting height.

•Grasp lift lever.

•Press plunger with thumb and move lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to

approximately 2-1/2 inches during the cool season and to over 3 inches

during hot months.

12