5 INSTALL DEFLECTOR GUARD (See Fig. 5)
1.Using the deflector guard as a template, hold deflector guard on the top of the deflector aligning edge with the holes with bottom of writing and angled end with the rear of the deflector as pictured.
2.Mark locations of (4) holes and drill using supplied #7 drill bit.
3.Insert screws from bottom through deflector and guard, place washer and then acorn nut on top of guard. Tighten with a screw driver and 3/8 wrench.
CAUTION: When using mower with out bagging attachment and with the blade supplied with this kit, the deflector guard must be installed.
DEFLECTOR
SHIELD
ACORN NUT
WASHER
SCREW DEFLECTOR
GUARD
Fig. 5
6 LOWER CHUTE (See Fig. 6)
1.Raise and hold deflector and metal shield in upright position.
2.Place slot in lower chute over mounting tab on mower and position lower chute over mower opening as shown.
3.Hook rear latch into flange hole on back of mower.
4.Hook front latch into tab hole on front of mower.
CAUTION: Do not remove deflector shield from mower. Raise and hold shield when attaching lower chute and allow it to rest on chute while in operation.
DEFLECTOR
SHIELD
TAB
FRONT
LATCH
REAR LATCH
Fig. 6
7