Tractor To Remove Mower, To Install Mower

1_ ARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER

VICE OR ADJUSTMENTS:

1.Depress clutch/brake pedal fully and set parking brake.

2.Place gearshift lever in neutral (N) position.

3.Place attachment clutch in "DISENGAGED" position.

4.Turn ignition key to "STOP" and remove key.

5.Make sure the blades and all moving parts have completely stopped.

6.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

Mower will be easier to remove from the right side of tractor.

1. Place attachment clutch in "DISEN-

IMPORTANT: If an attachment other than

the mower deck is to be mounted on the tractor, remove the front links and hook

the clutch spring Into square hole in frame.

GAGED" position.

Move attachment lift lever forward to lower mower to its lowest position.

1.	Raise attachment lift lever to its highest
	position.
2.	Slide mower under tractor with deflec-

3.Roll belt off engine pulley.

4.Remove small retainer spring, and remove clutch spring off pulley bolt.

5.Remove large retainer spring, slide

collar off and push housing guide out of bracket.

6.Disconnect anti-sway bar from chassis bracket by removing retainer spring.

7.Disconnect suspension arms from rear deck brackets by removing retainer springs.

8.Disconnect front links from deck by removing retainer springs.

9.Raise lift lever to raise suspension arms. Slide mower out from under trac-

tor.

Small

Clutch Spring

Small Retainer

Clutch

Retainer

Anti-Sway

Bar

- Large

HousingRetainer

GuideSpring

Bracket

	tor shield		to right side of tractor.
3.	Lower	lift	lever to its lowest position.
4.	Connect		front links to mower deck and
	secure	with retainer		springs.
5.	Connect		suspension	arms to rear
	deck brackets and secure with retainer
	springs.
6.	Connect		anti-sway bar to chassis
	bracket and secure with retainer spring.
7.	Push clutch cable housing guide into
	bracket, slide collar onto guide and
	secure with large retainer spring.

Pulley

_, (Both Sides)

3eflector