Craftsman 917.27267 owner manual Tractor, Battery, Fuel System, Cylinders

Page 27

Immediately prepare your tractor for stor- age at the end of the season or if the trac- tor will not be used for 30 days or more.

_WARNING: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this

manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power

leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see "TO CLEAN BATTERY AND TERMINALS" in the Maintenance section of this manual).

After cleaning, leave cables discon- nected and place cables where they

cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol blended fuels (called gasohol or using

ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine

at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car-

buretor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to start position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors

and cover it to give protection from dust and dirt.

Cover your tractor with a suitable pro- tective cover that does not retain mois-

ture. Do not use plastic. Plastic cannot breathe which allows condensation to

form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while

engine and exhaust areas are still warm.

27

Image 27
Contents IC.nFTSMnN,I Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentII. Slope Operation General OperationIV. Service III. ChildrenDo not Page Repair Protection Agreements Product SpecificationsSears Installation Service Customer ResponsibilitiesSeat HOW to SET UP Your Tractor Check Battery Checktire Pressure H L I,,,I Know Your Tractor HOW to USE YOU R Tractor Operate on Hills Before Starting the EngineTo Operate Mower To Stop Mower BladesADD Gasoline To Start EngineMulching Mowing Tips Mowing TipsLubrication ChartGeneral Recommendations Before Each USEBlade Removal BatteryTractor Brake OperationTo Change Engine OIL EngineAIR Filter BeltsSpark Plugs Clean AIR ScreenCleaning MufflerTractor To Remove Mower To Install MowerBelt Removal To Level Mower HousingSIDE-TO-SIDE Adjustment Belt InstallationTo Adjust Brake Tostart Engine with Aweak BAT- Tery Transaxle Gear Shift Lever NEU- Tral AdjustmentFront Wheel TOE-IN/CAMBER To Remove Wheel for RepairsTo Replace Fuse Replacing BatteryTo Replace Headlight Bulb Interlocks and RelaysFinal Setting To Adjust Throttle Control CableTo Adjust Carburetor Preliminary SettingCylinders BatteryTractor Fuel SystemProblem Troubleshooting ChartExcessive OFF SlowREoOII10LAC Tractor - Model Number SchematicTractor - Model Number Electrical KEY Part Description Tractor - Model Number 917.272670 Chassis and Enclosures KEY Part NO, NO,DESCRIPTION Tractor - Model Number Ground Drive Transaxle See Breakdown Tractor - Model Number 917.272670 Steering Assembly KEY Part NO. NO.DESCRIPTION KEY Part NO, NO. Description Tractor - Model Number EngineKEY Part Description Tractor - Model Number Seat AssemblyKEY Part Tractor - Model Number Decals1331 Tractor - Model Number Lift AssemblyTractor - Model Number Mower Deck Tractor - Model Number Mowerdeck Page 633 20@ 216/ 222 947 61 8o3A Briggs ENGINE-MODEL Number Tractor Model Number0230-E1 Briggs ENGINE-MODEL Number 31C707,TYPEPage Suggested Guide for Sighting Slopes for Safe Operation ARS