TO ADJUST STEERING WHEEL ALIGN-
MENT
If steering wheel crossbars are not hod- zontal (left to right) when wheels are posi- tioned straight forward, remove steering wheel and reassemble per instructions in the Assembly section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel
adjustable on your tractor: If damage has occurred to affect the front wheel
TO REMOVE WHEEL FOR REPAHRS o Block up axle securely.
o Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not Iose)o
o Repair tire and reassemble.
o On rear wheels only: align grooves in rear wheel hub and axle. Insert square
key.
o Replace washers and snap retaining ring securely in axle groove.
o Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant
may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.
Washers
The other vehicle must also be a 12 volt negative grounded system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES
o Connect each end of the RED cable to the POSITIVE (+)terminal of each bat- tery, taking care not to short against chassis.
o Connect one end of the BLACK cable to the NEGATIVE
charged battery.
o Connect the other end of the BLACK
cable to good CHASSIS GROUND, away from fuel tank and battery_
TO REMOVE CABLES, REVERSE ORDER
o | Remove | BLACK cable | first from | chassis | |
| and then from the fully | charged | battery° | ||
o | Remove | RED cable | last from both bat- | ||
| teries_ |
|
|
|
|
Positive Terminal | Negative Terminal | ||||
Retaining | Charged |
Ring | Battery |
| Positive Terminal |
| Negative Terminal |
| ! |
Axle Cover | '_ Square Key |
(Rear Wheel Only)
TO START ENGINE THAT HAS A WEAK
BATTERY
_kCAUTmON:
if your battery is too weak to start the engine, it should be recharged_ If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: '(ourtractor is equipped with a 12 volt negative grounded system.
24