TO REPLACE HEADLIGHT BULB o Raise hood.
o Pul! bulb holder out of the hole in the backside of the grill
o Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill°
o Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or pre- vent it from starting.
o Check wiring. See electrical wiring dia- gram in the Repair Parts section of this manual
TO REPLACE FUSE
Replace with 30 amp automotiveotype
TO REMOVE HOOD AND GRILL
ASSEMBLY
•Raise hood.
o Unsnap headlight wire connector.
o Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
o To replace, reverse above procedures_
Hood
Headlight
Wire
Connector
ENGUNE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers expense, may be performed by any non- road engine repair establishment or indi- vidual. Warranty repairs must be per- formed by an authorized engine manufac- turer's service outteL
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec_ essary. Check adjustment as described below before loosening cable, if adjust- ment is necessary, proceed as follows:
o With engine not running, move throttle control lever from stow to choke posi- tiono Slowly move lever from choke to fast position.
°Check that holes "A" in governor control lever and hole in governor plate
until holes are aligned. Tighten clamp screw securely.
Governor | Governor |
Control Lever | Control Plate |
\
Clamp
| Screw | Throttle |
| Cable | |
Holes "A" |
| |
|
|
25