Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes you need are listed below.
(1) | 3/4" | wrench | (1) | Pliers |
(1) | 1/2" | wrench | (1) | Utility knife |
(1) | Tire | pressure | gauge |
|
Insert
'@15/16 Hex Bolt
5/16 Lock
Washer
| Large Flat |
| Washer |
Steering | \ |
Wheel |
|
| Steering |
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1.Remove all accessible loose parts and parts boxes from carton.
2.Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat.
3.Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND BOOT
1.Slide extension shaft onto lower steer- ing shaft.
2.Place tabs of steering boot over tab slots in dash and push down to secure.
INSTALL STEERING WHEEL
3. | Position | front | wheels | of | the | tractor | so | |
| they are pointing straight forward. |
| ||||||
4. | Remove steering wheel adapter from | |||||||
| steering wheel and slide adapter onto | |||||||
| steering | shaft | extension. |
|
|
| ||
5. | Position | steering | wheel | so | cross | bars | ||
| are horizontal (left to right) and slide | |||||||
| inside boot and onto adapter. |
| ||||||
6. | Assemble | large | flat | washer, | 5/16 | lock | ||
| washer, 5/16 hex bolt and tighten |
| ||||||
| securely. |
|
|
|
|
|
|
|
7. | Snap steering | wheel | insert | into center | ||||
| of steering wheel. |
|
|
|
| |||
8. | Remove | protective | materials | from | trac- | |||
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
INSTALL SEAT
Adjust seat before tightening adjustment knob.
1.Remove adjustment knob and flat washer securing seat to cardboard
packing and set aside for assembly of seat to tractor.
2.Pivot seat upward and remove from the cardboard packing. Remove the cardboard packing and discard.
3.Place seat on seat pan so head of shoulder bolts are positioned over the large slotted holes in pan.
4.Push down on seat to engage shoulder
bolts in slots and pull seat towards rear of tractor.
5.Pivot seat and pan forward and as- semble adjustment knob and flat washer loosely. Do not tighten.
. Lower seat into operating position and
tor hood and grill. |
8
sit in seat.