TO REMOVE CABLES, REVERSE ORDER -
1.BLACK cable fi rst from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
Weak or Dead Battery
02614 |
Fully Charged Battery
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
REPLACING BATTERY
WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental grounding.
1. Lift hood to raised position.
2. Remove terminal guard.
3. Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
4. Install new battery with terminals in same position as old battery.
5. Reinstall terminal guard.
6. First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
7. Connect BLACK grounding cable to negative
maining hex bolt and keps nut. Tighten securely
8.Close terminal access doors.
9.Close hood.
Hex Bolt
Keps Nut
Terminal
Access
Door
Positive (Red) Cable
Terminal | Negative |
Guard | (Black) |
| Cable |
Replace with 20 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Hood
Headlight Wire
Connector
02495
25