Craftsman 917.27581 owner manual Storage, Battery, Other

Page 27

STORAGE

Immediately prepare your tractor for stor- age at the end of the season or if the trac- tor will not be used for 30 days or more.

CAUTION: Never store the tractor

with gasoline in the tank inside a building where fumes may reach an open fl ame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See “CLEANING” in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Maintenance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

Fully charge the battery for storage.

After a period of time in storage, battery may require recharging.

To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Maintenance section of this manual).

After cleaning, leave cables discon- nected and place cables where they cannot come in contact with battery terminals.

If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage. Also, alcohol

blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can dam- age the fuel system of an engine while in storage.

Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car- buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to “START” position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your tractor indoors and cover it to give protection from dust and dirt.

Cover your tractor with a suitable pro- tective cover that does not retain mois- ture. Do not use plastic. Plastic cannot

breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

27

Image 27
Contents Lawn Tractor Warranty Table of ContentsGeneral Operation Safety RulesIV. Towing Service Safe Handling of GasolineII. Slope Operation III. ChildrenGeneral Service Repair Protection Agreements Product SpecificationsSears Installation Service Customer ResponsibilitiesSteering Wheel Unassembled PartsBefore Removing Tractor from Skid ASSEMBLY/PRE-OPERATIONTools Required for Assembly To Remove Tractor from CartonCheck Battery Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation ROS on Know Your TractorHOW to USE Your Tractor Using the Reverse Operation System To Operate MowerOperating in Reverse To Start Engine Before Starting the EngineMowing Tips Before Each USE MaintenanceLubrication Chart General RecommendationsTractor Belts BatteryEngine Transaxle CoolingAIR Filter Muffler Clean AIR ScreenEngine OIL Filter Engine Cooling SystemTo Remove Mower Service and AdjustmentsCleaning To Install MowerTo Replace Mower Blade Drive Belt To Level Mower HousingSIDE-TO-SIDE Adjustment Belt InstallationTo Replace Motion Drive Belt To Check and Adjust BrakeTo Adjust Brake To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEU- Tral AdjustmentTo Adjust Steering Wheel ALIGN- Ment To Remove Wheel for RepairsInterlocks and Relays To Replace Fuse Replacing BatteryTo Remove CABLES, Reverse Order To Replace Headlight BulbFinal Setting To Adjust Throttle Control CableTo Adjust Carburetor Preliminary SettingBattery StorageOther Problem Cause Correction Troubleshooting ChartExcessive Mower blades will Suggested Guide for Sighting Slopes for Safe Operation Get it fixed, at your home or ours