Craftsman 917.273823 Before Starting the Engine, To Start Engine, Check Engine OIL Level

Page 15

Transmission Engaged

Transmission Disengaged

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH-

MENTS

Tow only the attachments that are recom- mended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

1.Check engine oil with tractor on level ground.

2.Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, re- move and read oil level. If necessary.

add oil until "FULL' mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting ((See the oil viscosity chart in the Maintenance section of this manual).

To change engine oil, see the Mainte- nance section in this manual.

ADD GASOLINE

Fill fuel tank to bottom of tank filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quanti-

ties that can be used within 30 days to assure fuel freshness.

_CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: When operating in tempera- tures below 32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separa- tion and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel

next season. See Storage Instructions for additional information.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Be sure freewheel control is in the transmission engaged position.

2.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

3.Place motion control lever in neutral

(N)position.

4.Move attachment clutch to disengaged position.

5.Move throttle control to choke position. NOTE: Before starting, read the warm and cold starting procedures below.

6.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do

not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try

again. If engine still does not start, move the throttle control back to the

choke position and retry.

WARM WEATHER STARTING (50 ° F and

above)

7.When engine starts, move the throttle control to the fast position.

15

Image 15
Contents Crrftsmrni Limited Warranty on Battery Limited Warranty on Craftsman Riding EquipmentII. Slope Operation General OperationIII. Children Do notMow up and down slopes 15 Max, not across Repair Protection Agreements Sears Installation ServiceProduct Specifications Customer ResponsibilitiesSteering Wheel Before Removing Tractor from Skid Attach Steering Wheel Howto SET UP Your TractorTo Remove Tractor from Carton Unpack CartonTo Drive Tractor OFF Skid Install SeatCheck for Proper Position of ALL Belts Install Mulcher PlateCheck Deck Levelness Discharging@@@@@ Know Your Tractor To USE Throttle Control HOW to USE Your TractorTo Adjust Mower Cutting Height To SET Parking BrakeTo Stop Mower Blades To Adjust Gauge WheelsTo Operate On Hills To Operate MowerCheck Engine OIL Level Before Starting the EngineTo Start Engine Towing Carts and Other Attach MentsAutomatic Transmission Warm UP Purge TransmissionMulching Mowing Tips Mowing TipsCSF General RecommendationsLubrication Before Each USEOperator Presence System TractorBrake Operation TiresBelts EngineTransaxle Cooling Transaxle Pump FluidEngine Cooling System Clean AIR ScreenAIR Filter Engine OIL FilterIN-LINE Fuel Filter CleaningMuffler Spark PlugsTo Remove Mower Service or AdjustmentsTo Install Mower TractorBelt Removal To Level Mower HousingSIDE-TO-SIDE Adjustment FRONT-TO-BACK AdjustmentTo Replace Motion Drive Belt To Adjust BrakeBelt Installation To Check and Adjust BrakeTo Start Engine with a Weak BAT Tery Replacing Battery To Replace Headlight BulbTo Remove Hood and Grill AS Sembly Acceleration Test To Adjustthrottle Control CablePreliminary Setting To Adjust CarburetorTractor BatteryFuel System OtherTroubleshooting Chart ProblemCause Correction Vibration ProblemcausecorrectionOFF Problem Cause CorrectionBattery Tractor - Model Number SchematicTractor - Model Number Electrical Harness, Ignition KEY Part DescriptionTractor - Model Number 917.273823 Chassis and Enclosures 184265 Bezel Grille Tractor - Model Number Ground Drive Transaxle See Breakdown KEY Part DescriptionTractor - Model Number 917.273823 Steering Assembly Tractor - Model Number 917.273823 Steering Assembly KEY Part Tractor - Model NumberEngine Optional EquipmentKEY Part NO. NO.DESCRIPTION Tractor - Model Number 917.273823 Seat AssemblyTractor - Model Number Decals Wheels & Tires KEY Part DescriptionTire, Front Tractor - Model Number Lift Assembly Ring173288 Link Front Tractor - Model Number Mower Deck STD624008 Retainer Spring 104 STD551110 Los Brake Pad Plate 750 IDFSl 1022 914 729 Exhaust Cylinder HeadPin-Piston Casing ClampPlate-Trim Pump-FuelSuggested Guide for Sighting Slopes for Safe Operation Your Home