Craftsman 917.27184 owner manual Mulching Mowingtips

Page 18

MOWINGTIPS

Mower should be properly leveled for

best mowing performance. See =TO

LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual.

The left hand side of mower should be used for trimming.

Drive so that clippings are discharged onto the area that has been cut. Have

the cut area to the dght of the tractor. This will result in a more even distribu-

tion of clippings and more uniform cutting.

When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand tums until finished.

If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

Always operate engine at full throttle when mowing to assure better mowing performance and proper discharge of material. Regulate ground speed by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

When operating attachments, select a ground speed that will suit the terrain

and give best performance of the attachment being used.

f

4p.

MULCHING MOWINGTIPS

IMPORTANT: For best performance, keep mower housing free of built-up grass and trash. Clean after each use.

The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this willprov_le the best recutting action of the blades.

Avoid cutting your lawn when it is wet.

Wet grass tends to form clumps and interferes with the mulching action.

The best time to mow your lawn is the early eftemoon. At this time the grass has dried and the newly cut area will not be exposed to the direct sun.

For best results, adjust the mower cutting height so that the mower cuts off only the top one-third of the grass blades. For extremely heavy mulching, reduce your width of cut on each pass and mow slowly.

Certain types of grass and grass conditions may require that an area be mulched a second time to completely hide the clippings. When doing a second cut, mow across or perpendicu- lar to the first cut path.

Change your cutting pattern from week to week. Mow north to south one week

then change to east to west the next week. This will help prevent matting and graining of the lawn.

t

J

18

Image 18
Contents ICRRFTSMRNel Limited 90 DAY Warranty on Battery General Operation Slope OperationIV. Service III. ChildrenSafety is Involved Repair Agreement 17/32 x 1-3/16x 12 Gauge Tools Required for Assembly To Remove Tractor from Carton Unpack CartonBefore Removingtractor from Skid Attach Steering Wheel Install Seat Packing and set aside for assembly of seat to tractorCheck Brake System Check Deck LevelnessCheck for Proper Position of ALL Belts To Convert to Bagging or DischargingChecklist Before YOU Operate and EnjoyRlR N H L Engine speed Howto Useyourtractor StoppingTo Operate on Hills To Adjust Gauge WheelsTo Operate Mower To TransportADD Gasoline Towing Carts and Other AI-FACHMENTSBefore Startingthe Engine Check Engine OIL Level To Start EngineAutomatic Transmission Warm UP PurgetransmissionMowingtips Mulching MowingtipsGeneral Recommendations Lubrication Chart Before Each USEOperator Presence System Brake OperationTires Blade CareTransaxle Pump Fluid BeltsTransaxle Cooling Engine LubricationEngine Cooling RNS Clean AIR ScreenTo Service PRE-CLEANER AIR FilterTo Level Mower Housing CleaningTo Install Mower TractorSIDE-TO-SIDE Adjustment To Replace Mower Blade Drive BeltBelt Removal To Replace Motion Drive Belt To Adjust BrakeTransaxle Motion Control Lever Neutral Adjustment With Parking BrakeReplacing Battery To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery Transmission REMOVAUREPLACE- MentEngine Final Setting To Adjust CarburetorPreliminary Setting Acceleration TestEngine Fuel System To Clean Battery and TermiTractor Engine OILProblem CauseCorrection Troubleshooting Chart CauseChart CorrectionSchematic Tractor - Model NumberTRACTOR- Model Number Lectrical Electrical KEY Part DescriponTractor -- Model Number 917.271840 Chassis and Enclosures Tractor - Model Number 917.271840 Chassis and Enclosures KEY Part NO. no DescriptionTractor - Model Number 3ROUND Drive Tractor - Model Number Ground Drive KEY Part DescriptionTractor - Model Number 917.271840 Steering Assembly KEY Part Description Engine Optional EquipmentEngine TRACTOR--MODELNUMBER917.271840 Seatassembly Part KEY DescriptionWheels &TIRES KEY PartTRACTOR- Model Number Lift Assembly KEY Part NO. NO.DESCRIPTION \ ..-% !i Tractor - Model Number Mower DeckTRACTOR-- MODELNUMBER917.271840 Mowerdeck Rim 316x1.5Ox.1046 Instructionmanual 5a4P75 5o91 Gasket SETKEY Part NO. no RPM261463 Page Page Only Ride UP and Down Hill Sighting Not Across Hill GuideGet it fixed, at your home or ours