_R
Always observe safety rules when
performing any maintenance.
BRAKE OPERATION
If tractor requires more than six (6) feet stopping distance at high speed in highest
gear, then brake must be adjusted. (See "TO ADJUST BRAKE in the Service and
Adjustments section of this manual),
TIRES
•Maintain proper air pressure in all tires (See "PRODUCT SPECIFICATIONS" section of this manual).
•Keep tires free of gasoline, oil, or insect contmt chemicals which can harm rubber.
•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.
NOTE: To seastire punctures and prevent flat tires due to slow leaks, tire sealant may
be purchesed from your local parts dealer.
Tire sealant also prevents tire dry rot and corrosion.
OPERATOR PRESENCE SYSTEM
Be sure operator presence and intedock
systems are working properly. If your tractor does not function as described,
repair the problem immediately.
•The engine should not start unless the clutch/brake pedal is fully depressed and attechement clutch control is in the
disengaged position.
•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake shouSd shut off the engine.
•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat sho_k:lshut off the engine.
•The attachment clutch should never
operate unless the operator is in the seat.
BLADE CARE
Far best results mower blades must be
kept sharp. Replace bent or damaged blades.
BLADE REMOVAL
I.Raise mower to highest position to a$$owaccess to blades.
2.Remove hex bolt, lock washer and flat washer securing blade.
3.install new or resharpened blade with
trailing edge up towards deck as
Shown.
IMPORTANT: To ensure proper assembly, center hole in blade must align with star on mandrel assembly.
4, Reassemble hex bolt, lock washer and fiat washer in exact order as shown.
5.Tighten bolt securely
IMPORTANT: Blade bolt is grade 8 heat treated.
Trailing_ Blade Center.J_
Edge Up ((/_.\ | Hole _ | _'_ |
Lock Washer "_'_ =_'_ Assembly
Hex Bolt | "_ | Star | |
(Grade)*'_ | Flat Washer/_ |
|
*A Grade 8 heat treatedbolt can be identified by six lineson the bolt head.
TO SHARPEN BLADE
NOTE: We do not recommend sharpening
blade - but if you do, be sure the blade is balanced.
Care should be taken to keep the blade balanced. An unbalanced blade will
cause excessNe vibration and eventual damage to mower and engine.
•The blade can be sharpened with a file or on a gdnding wheel. Do not attempt to sharpen while on the mower.
•To check blade balance, you will need a 5/8" diameter steel bolt, pin, or a cone balancer. (When using a cone balancer, follow the instructions supplied with
balancer.)
NOTE: Do not use a nail for balancing blade. The lobes of the center hole may
appear to be centered, but are not.
•Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a hodzontal position. If either end of the bSede moves downward, sharpen the heavy end until the blade is balanced.
/
5/8" Bolt or Pin
Center Hole
BATTERY
Your tractor has a batterycharging system which is sufficient for normal use. How-
ever, pedndic charging of the battery with an automotive charger will extend its life.
•Keep battery and terminals clean.
•Keep battery botts tight.
•Keep small vent holes open.
•Recharge at
2O