Craftsman 917.272233 owner manual Troubleshooting Chart Problemcause

Page 31

TROUBLESHOOTING CHART

PROBLEMCAUSE

Loss_power	1.		Cuffingtoo muchgras_oo
			fast.
	2.		Throttle in =CHOKE"
			position.
	3.	Build-up of grass, leaves
			and trash under mower.
	4.		Dirty air filter.
	5.	Low oil level/dirty oil.
	6.		Faulty spark plug.
	7.		Dirty fuel filter.
	8.	Stale or dirtyfuel.
	9.		Water in fuel.
	10.Spark plug wire loose.
	11. Dirty engine air screen/fins.
	: 12.Dirty/clogged muffler.
	13. Loose or damaged wiring.
	14.Carburetor out of
			adjustment.
	15.Engine valves out of
			adjustment.
Excessive	1.		Worn, bent or loose blade.
_bratlon	2.		Bent blade mandrel.
	2.		Bent blade mandrel.
	3.		Loose/damaged part(s).
Englnecontlnues	1. Faulty operator-safety
to run			presence control system.
when operator
leaves seat
with attachment
clutch engaged
Poorcut-uneven	1.		Worn, bent or loose blade.
	2.		Mower deck not level.
	3.		Buildup of grass, leaves,
			and trash under mower.
	4.		Bent blade mandrel.
	5. Clogged mower deck vent
			holes from buildup of

grass, leaves, and trash around mandrels.

CORRECTION

1.Set in "Higher Cut" position/ reduce speed.

2.Adjust throttle control.

3.Clean underside of mower housing.

4.Clean/replace air filter.

5.Check oil level/change oil.

6.Clean and regap or change spark plug.

7.Replace fuel filter.

8.Drain fuel tank and refill with fresh gasoline.

9.Drain fuel tank and carbure- tor, refill tank with fresh gasoline and replace fuel filter.

10.Connect and tighten spark plug wire.

11.Clean engine air screen/fins. 12.Clean/replace muffler. 13.Check all wiring.

14. See "To Adjust Carburetor"

in Service Adjustments section.

15.Contact a Sears or other qualified service center.

1.Replace blade. Tighten blade bolt.

2.Replace blade mandrel.

3.Tighten loose part(s). Replace damaged parts.

1.Check wiring, switches and connections. If not corrected, contact a

Sears or other qualified service center.

1.Replace blade. Tighten blade bolt.

2.Level mower deck.

3.Clean underside of mower housing.

4.Replace blade mandrel.

5.Ctean around mandrels to open vent holes.

31

Image 31

Contents Icrrftsmrn Limitedtwoyear Warranty on Craftsman Riding Equipment Parts Slope Operation General OperationDo not When necessary Mower blades are sharp and can cut IV. ServiceIlL Children Defects or other reproductive harm. Wash hands after handUng Charging Battery AMP/HRSasoline 3,5 Gallons Capacity Unleaded Andtype Regular ReverseKnob Mower Retainer SpringsHer 2FlangedTo Removetractor from Carton Tools Required for AssemblyHowto SET Upyourtractor Install SeatAssemble Gaugewheelsto Mower Deck PlaceseatonseatpansoheadofTabHole Nose Roller Lock Nut B Bracket Install hex bolts and look nuts asInstall Mower and Drive Belt Plate assembly and mower bracketsCheck Brake System Check Tire PressureCheck Mower Levelness BeltsRlR Knowyourtractor Ground Drive To Adjust Mower Cutting HeightHowto Useyourtractor To SET Parking Brake Stopping Mower BladesTotransport To Adjust Gauge WheelsTo Operate on Hills To Operate MowerTo Start Engine Towing Carts and Other AI-FACH- MentsBefore Startingthe Engine Check Engine OIL Level ADD GasolineMOWlNGTIPS Cold Weather Starting 50 F and belowBefore Each USE General RecommendationsOperator Presence System TractorBrake Operation TiresTo Change Engine OIL To Clean BAI-FERYAND TerminalsTransaxle Cooling Engine LubricationEngine OIL Filter Clean AIR INTAKE/COOLING AreasTo Service Cartridge CleaningTractor To Install MowerTo Level Mower Housing SIDE-TO-SIDE AdjustmentIdlers to see that they rotate freely Both Frontlinks Must be Equal LengthImportant Deck must be level side-to To Replace Mower Drive BeltWith Parking Brake Engaged Mower Drive Belt InstallationTo Adjust Brake To Replace Mower Blade Drive BeltFront wheel toe-in and camber are Transaxle Gear Shift Lever Neutral AdjustmentTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Replace Fuse To Replace Headlight LampTo Attach Jumper Cables Interlocks and RelaysTighten clamp screw securely To Remove Hood and Grill AssemblyTo Adjust Throttle Control Cable To Adjust Choke ControlAcceleration Test To Adjust CarburetorRecheck idle speed. Readjust if necessary Final SEI-IINGCylinders BatteryEngine Fuel System Engine OILDirty fuel filter Troubleshooting Chart Problem Cause CorrectionReplace spark plug Clean/replace air filter Bad spark plugTroubleshooting Chart Problemcause Roubleshooting Chart Problem Cause Tractor - Model Number SchematicTernator Tractor --MODEL Number KEY Part Description Tractor - Model Number 917.272233 Chassis and Enclosures KEY Part Description Tractor -- Model Number Ground Drive EVX Tractor - Model Number Ground DriveTractor --MODEL Number 917.272233 Steeringassembly Tractor --MODEL Number 917.272233 Steering Assembly Tractor -- Model Number Engine+ !i KEY Part NO. NO. Description Tractor -- Model Number Seat AssemblyWheels &TIRES DecalsTractor - Model Number Mowerdeck Tractor -- Model Number Mowerdeck 160 Part Descr 111 Crankcase KEY Part NO, NO.DESCRIPTION HEAD/VALVE/DREATHER KEY Part NO. NO.DESCRIPTIONIgnitionielectrica Not Illustrated Blower Housing & Baffles KEY Part NO. NO.DESCRIPTIONIGNITION/CHARGING KEY Part NO. NO.DESCRIPTION AIR INTAKE/FILTRATIONStarting System Engine Controls Engine Controls KEY Part NO. no Description Keypart NO. no DescriptionKeypart NO. no Fuel Svstmel KEY Part NO. no Description Page Only Ride UP and Down Hill Not Across Hill Suggested Guide for Sighting Slopes for Safe Operation179435 5.2.01 TR Anydaye,cxrkjhtU.S.Aody