Craftsman 917.271815 owner manual Battery, Tractor, Fuel System, Engine OIL, Cylinders

Page 29

Immediately prepare your tractor for

storage at the end of the season or if the tractor will not be used for 30 days or

more.

/kCAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter

storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire tractor (See "CLEANING" in the Maintenance section of this manual).

2.Inspect and replace belts, if necessary (See belt replacement instructions in the Service and Adjustments section of this manual).

3.Lubricate as shown in the Mainte- nance section of this manual.

4.Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

5.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be disconnected and battery cleaned thoroughly (see

"TO CLEAN BATTERY AND TERMI- NALS" in the Maintenance section of this manual).

•After cleaning, leave cables discon- nected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposites from forming in essential fuel system parts such as carburetor, fuel hose, or tank during storage.

Also, experiance indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

1.Drain the fuel tank.

2.Start the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or

storage container. Always follow the mix ratio found on stabilizer container. Run

engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach

the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER(S)

1.Remove spark plug(s).

2.Pour one ounce of oil through spark plug hole(s) into cylinder(s).

3.Turn ignition key to "START" position for a few seconds to distribute oil.

4.Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your

gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows conden- sation to form and will cause your

tractor to rust.

IMPORTANT: Never cover tractor while engine and exhaust areas are still warm.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Craftsmiihi Limited 90 DAY Warranty on Battery II. Slope Operation General OperationDo not IV. ServiceIII. Children Page Customer Responsibilities Repair AgreementSeat HOW to SET UP Your Tractor Tools Required for AssemblyTo Remove Tractor from Carton Before Removing Tractor From Skid Attach Steering WheelFunction of controls Install SeatDischarging Install Mulcher PlateCheck Tire Pressure Check Deck LevelnessChecklist Free Wheel Plunger Know Your TractorTo SET Parking Brake HOW to USE Your TractorStopping To USE Throttle ControlTo Adjust Gauge Wheels To Operate Mower To Adjust Mower Cutting HeightTo Operate on Hills ShoulderTo Transport Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelTo Start Engine Mulching Mowing Tips Mowing TipsLubrication Chart Maintenance ScheduleGeneral Recommendations Before Each USEOperator Presence System Brake OperationBlade Care Blade RemovalEngine BatteryBelts Transaxle CoolingMuffler Clean AIR ScreenSpark Plugs IN-LINE Fuel FilterTo Install Mower CleaningTractor To Remove MowerSIDE-TO-SIDE Adjustment To Level Mower HousingTo Replace Mower Blade Drive Belt Belt RemovalTo Replace Motion Drive Belt To Adjust BrakeTransaxle Gear Shift Lever Neutral Adjustment Front Wheel TOE-IN/CAMBER To Adjust Steering Wheel ALIGN- MentTo Remove Wheel for Repairs To Attach Jumper CablesTo Replace Headlight Bulb To Remove Hood and Grill AssemblyInterlocks and Relays To Replace FusePreliminary Setting To Adjust Choke ControlFinal Setting Acceleration TestTractor BatteryFuel System Engine OILCause Correction Troubleshooting ChartProblem Engine valves out of adjustment OFF Problem CauseSlow Your Tractor iS Tractor --MODEL NU Mber26I Wire Loop 163465 Battery 12 Volt 28 AMPTractor --MODEL NU MB ER ElectricalTractor Model Number Chassis and Enclosures Tractor -- Model Numb ER Chassis and Enclosures Tractor -- Model NU Mber Ground Drive Transaxle See Breakdown Belt, Center Span All component dimensionsPeerless 206-545C Bolt, Hex 7/16-20Steering TRACTOR-- Model Number6855M 175131 Axle AssemblyTractor --MODEL N Umber Engine Throt Paddle Tractor Model NU Mber17720408 144069Tractor --MODEL Number Seat Assembly Wheels and Tires Tractor -- Model NU MberDecals Tractor -- Model Number Lift Assembly 17 165689 Trunnion Tractor --MODEL Number Lift AssemblyLift Lever Inner Wire Assembly Tractor --MODEL Number Mower Deck Tractor -- Model Number7O 8A Bearing 5/8 792076A Dowel PinLever 792085APage 297 643 3341 267 Engine Gasket SET LABEL-EMISSIONKEY Part NO. no Wrench-Spark Page Page Suggested Guide for Sighting Slopes for Safe Operation Sears.RoebtxkandCo Www,larco11

917.271815 specifications

The Craftsman 917.271815 is a powerful and efficient riding mower designed to meet the demands of homeowners who want to maintain a well-groomed lawn with ease. This mower is equipped with a rugged and reliable engine, ensuring consistent performance and longevity. With its user-friendly design and innovative features, the 917.271815 stands out as a top choice for landscaping tasks.

One of the main features of the Craftsman 917.271815 is its robust engine. Powered by a 21-horsepower Briggs & Stratton engine, this riding mower provides ample power to tackle tough terrains and thick grass with minimal effort. The engine's innovative technology promotes efficient fuel consumption, allowing users to mow larger areas without frequent refueling.

The mower’s cutting deck is another highlight. It features a 42-inch cutting width, allowing for a wide mowing path that reduces the time spent mowing. The adjustable cutting height, ranging from 1 to 4 inches, gives users the flexibility to achieve the desired lawn height, ensuring a professional-looking finish.

Ergonomically designed for comfort, the Craftsman 917.271815 features a high-back commander’s seat, providing excellent support during extended mowing sessions. The intuitive control layout, including a sleek steering wheel and foot pedal operation, enhances maneuverability, making it easy to navigate around obstacles in the yard.

Safety is paramount in the design of the 917.271815. It incorporates several safety features, including an automatic safety shut-off that activates when the operator leaves the seat. This technology prevents accidents and enhances user safety while mowing.

The mower's durable construction ensures it can withstand the rigors of regular use. With heavy-duty materials used throughout, the Craftsman 917.271815 is designed to resist wear and tear, reducing the need for frequent repairs. Additionally, the mower features a reliable transmission system that allows for smooth operation and easy shifting between speeds.

Another significant aspect is the mower's versatility. It can be equipped with various attachments, transforming it into a multi-functional tool for various yard tasks, such as leaf collection, snow removal, and more.

Overall, the Craftsman 917.271815 is a well-rounded riding mower that combines power, comfort, and versatility, making it an excellent choice for homeowners looking to maintain their lawns efficiently. With its advanced features and durable design, it promises to deliver top performance season after season.
Top Page Image Contents