REPLACING BA'FrERY
_CAUTION: Do not short battery
terminals by allowing a wrench or any other object to contact beth terminals at
the same time. Before connecting battery, remove metal bracelets, wristwatch
bands, dngs, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
7.Connect BLACK grounding cable to negative
Tighten securely
8.Close terminal access doors.
9.Close hood.
| Keps ,Nutr | ||
| .. | _Bolt | |
Terminal | _; |
| |
Door | ' ".... |
|
|
Access | "_e |
|
|
Terminal |
|
| Cable (Red) |
Guard__qB_ca_i_; | Negativeable | ||
|
|
| |
TO REPLACE | HEADLIGHT LAMP | ||
CAUTION: When lit, the halogen lamps
get extremely hot. Hold lamp assembly by the holder and do not touch the bulb.
1.Raise hood.
2.Disconnect harness from lamp assembly.
3.Rotate counterclockwise and pull lamp assembly out of the hole in the backside of the gdll.
4, Insert new lamp assembly and rotate clockwise to lock.
5.Reconnect harness to lamp assembly.
6.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractorto run pnerly,stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL ASSEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.To re )lace, reverse above procedure.
nector
ENGINE
Maintenance, repair, or replacement of
the emission control devices and systems, which are being done at the customers
expense, may be performed by any non- road engine repair establishment or individual. Warranty repairs must be
performed by an authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as de- scribed below before loosening cable. If adjustment is necessary, proceed as follows:
1.With engine not nJnning,move throttle control lever to fast position.
2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw.
Tighten clamp screw securely.
27