SERVNCE AN ADJUSTMSNTS
.._==H..u= ...11.. | N==u,i i., u= |
i.u.,. =
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
°Depress clutch/brake pedal fully and set parking brake.
. | Place | gearshift | lever in | "NEUTRAL" position. |
. | Place | attachment | clutch | in "DISENGAGED" position. |
| Turn ignition key "OFF" and remove key. |
aMake sure the blades and all moving parts have completely stopped.
oDisconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TRACTOR
SEE NOTE ABOVE
CORRECT
TO REMOVE MOWER (See Fig. 17)
Mower wilt be easier to remove from the right side of tractor,
•Place attachment clutch in "DISENGAGED" position.
•Move attachment lift lever forward to lower mower to its lowest position.
•Roll belt off engine pulley.
•Disconnect clutch rod from clutch lever by removing retainer spring,
•Disconnect suspension arms from rear deck brackets by removing retainer springs_
,Disconnect front links from deck by removing retainer springs_
•Raise lift lever to raise suspension arms. Slide mower out from under tractor,
IMPORTANT; iF AN ATTACHMENT OTHER THAN THE
MOWER IS TO BE MOUNTED TO THE TRACTOR, TIdE R.H, AND Loll, SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR.
)_TRUNNION
TRUNNION
POSITION
CLUTCH
RODRETAINER SPRING
TO INSTALL MOWER (See Fig. 17)
•Raise attachment lift lever to its highest position°
•Slide mower under tractor with discharge guard to right side of tractor.
•Lower lift lever to its lowest position.
. Install mower in reverse order of removal instructions. NOTE: The mower clutch rod has a trunnion that has been
preset at the factory for optimum mower performance. DO NOT MOVE THE TRUNNION ON THE CLUTCH ROD. If for any reason the trunnion has been moved on the clutch rod, it must be reset to correct position (parallel with clutch rod) and measure
Be sure to tighten trunnion nut securely against trunnion after making any adjustments.
RETAINER
SPRINGS
RETAINER
SPRINGS
ENGINE
PULLEY
FIG. 17
18