STEP 3: (SEE FIGURE 3)
,insert the ends of the base leg tubes into the upper base tube,
UPPER BASE TUBE
]
LJ
]J
i]
BASELEG TUBES
FIGURE 3
STEP 4: (SEE FIGURE 4)
,Raise the tractor seat and remove the seat springs and the four bolts from the rear fender using a 1/2" sockeL
,Place the base leg tubes onto the rear fender. Attach the front support brackets to the front holes in the fender reusing the bolts that were removed. If seat springs were mounted to front holes, see note below. Do not tighten completely.
Attach the base bracket and the seat springs to the rear holes in the fender using the new 5/16" x 1" bolts
(E)and 5/16" flat washers (H) supplied with the Snow Cab, If seat springs were mounted to front holes, see note below, Do not tighten completelyo
,Tighten the nuts and bolts that fasten the base leg tubes to the base bracket and front support brackets,
,Center the base leg tubes on the rear fender and then tighten, using moderate force, the bolts fastening the base bracket and the front support brackets to
the fender, Overtightening the bolts may damage the threaded holes in the fender,
"PROCEEDTO STEP 8 ON PAGE 7
NOTE: If seat springs were mounted to front holes, use 5/16" x 1" bolts (E) and 5/16" flat washers (H) to attach seat springs and front support brackets to front holes, Use origina! bolts to attach base bracket to rear holes,
5/16" x 1"' HEX BOLT (E)
5/16" WASHER (H)
SPRING
SEE NOTE)
INSTRUCTIONS FOR TRACTORS WiTH DUAL
SUSPENSION BRACKETS
STEP 5: (SEE FIGURE 5)
Attach the right base bracket to the front holes of a base leg tube that does not have a flattened end, using two 5/16" x 2o3/4" carriage bolts (A), two spacers (J) and two 5/16" nylock nuts (G). Make onty finger tight. Repeat for the left base bracket.
|
| 5/16" NYLOCK NUT (G) |
SPACER | (J) | / |
5/16" x 2o3/4" |
| |
CARRIAGE BOLT (A) |
|
|
LEFT BASE
BRACKET
FIGURE 5
STEP 6: (SEE FIGURE 6)
Insert the ends of the base leg tubes into the upper base tube,
UPPER BASE TUBE
BASE LEG TUBES
FIGURE 6
FIGURE 4