Craftsman 486.24276 manual Front Flap Elastic Hook

Page 8

STEP 10: (SEE FIGURE 10)

,Raise the tractor's hood.

,insert the ends of the front brace rod into the inner set of holes in the U-tube and rest the bottom of the brace rod on the dash pane!. If the brace rod is too long to rest on the dash panel, you can shorten the overall length of the rod by inserting the upper ends of the rod into one of the wider spaced sets of holes.

STEP 11: (SEE FIGURE 11)

,With the tractor's hood still raised, place the snow cab canopy onto the tubing frame and drape the front flap down in front of the tractor% dash panel. Lower the hood, trapping the front flap under the hood. Secure the sides of the canopy by fastening the elastic hooks to the bottom edge of the footrest and fender. Tie the straps at back of canopy to the upright tubes. Any levers or handles on snow throwers or snow blades should be located outside of the cab.

LOWER

HOOD

/

FRONT BRAOE ROD

RAISE HOOD

FIGURE 10

FRONT FLAP

/ELASTIC HOOK

t

FIGURE 11

Image 8
Contents Operators Manual Mode No Parts ORDERING/SERVICE Serial Number Date of PurchaseShown Full Size Not Shown Full Size QTY DescriptionRightBaseBracketstampedwithR Tools Required for Assembly Removal of Parts from CartonSee Figure NylockSuspension Brackets See FigureProceedto on Carriage Bolt aCompleting Assembly ALL Tractors Knob LFront Flap Elastic Hook Cleaning Customer ResponsibilitiesCheck for Loose Fasteners StorageRepair Parts for Model 486.24276 Snow CAB RER Part QTY Part QTYOa,,ant,dao,o,o,S,tsodOanada