•To check blade balance, drive a nail into a beam or wall. Leave about one
inch of the straight nail exposed. Place center hole of blade over the head of
the nail. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward,
sharpen the heavy end until the blade is balanced.
| Crank shaft |
Blade adapter | keyway |
Crank
BoR
Hardened
Blade
washer edge adapter
GRASS CATCHER
•The grass catcher may be hosed with water, but must be dry when used.
•Check your grass catcher often for
damage or deterioration. Through normal use it will wear, If catcher needs
replacing, replace only with a manufac- turer approved replacement catcher. Give the lawn mower model number
when ordering.
ENGINE
LUBRICATION
Use only high quality detergent oil rated with API service classification
Select the oil'sSAE viscosity grade according to your expected operating temperature.
SAE Vk_COSITY GRADES
NOTE: Although
cold weather, these
possible engine damage from running low on oil.
Change the oil after every 25 hours of operation or at least once a year if the lawn mower is not used for 25 hours in
one year.
Check the crankcase oil level before
starting the engine and after each five (5) hours of continuous use. Tighten oil plug securely each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to drain oil, drain fuel tank by running engine until fuel tank is empty.
1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with spark plug.
2.Remove engine oil cap; lay aside on a clean surface.
3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to
remove any oil trapped inside of engine.
4.Wipe off any spilled oil on lawn mower and on side of engine.
5.Fill engine with oil. (See "Add Oil" in the Operacion section of this manual.)
6.Reconnect spark plug wire to spark plug.
AIR FILTER
Your engine will not run properly and may be damaged by using a dirty air filter.
Replace the air filter every year, more often if you mow in very dusty, dirty conditions.
TO CLEAN AIR FILTER
t.Loosen screw and tilt cover to remove.
2.Carefully remove cartridge.
3.Clean by gently tapping on a flat
surface. If very dirty, replace cartridge.
ACAUTION: Petroleum solvents, such as kerosene, are not to be used to clean cartridge. They may cause deterioration of the cartridge. Do not oil cartddge. Do not use pressurized air to clean or dry cartridge.
4.Install cartridge, then replace cover making sure the tabs are aligned with the slots in the back plate. Fasten screw securely.