Craftsman 388 Howto Useyour Lawn Mower Engine Speed Control, Engine Zone Control, Convert Mower

Page 7

The operation of any lawn mower can result in

foreign objects thrown into the eyes, which can result in severe eye damage.

Always wear safety glasses or eye shields while operating your lawn mower or performing any adjustments or repairs.

We recommend a wide vision safety mask over spectacles or standard safety glasses.

HOWTO USEYOUR LAWN MOWER ENGINE SPEED CONTROL

The engine speed was set at the factory for optimum performance. Speed is not adjustable.

ENGINE ZONE CONTROL

_,CAUTION: Federal regulations require

an engine control to be installed on this lawn mower in order to minimize the risk

of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running.

Your lawn mower is equipped with an operator presence control bar which

requires the operator to be positioned behind the lawn mower handle to start and operate the lawn mower.

TO ADJUST CUTTING HEIGHT

Raise wheels for low cut and lower wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.

To change cutting height, squeeze adiuster lever toward wheel. Move

wheel up or down to suit your require- ments. Be sure all wheels are in the

same setting.

NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. Also, 9-position adjusters (if so equipped) allow lever to be positioned between the plate tabs.

LowerWheels for High Cut

ever

RaiseWheels for Low Cut

[O CONVERT MOWER

Your lawn mower was shipped ready to be used as a muleher. To convert to

bagging or discharging:

REAR BAGGING

Lift rear door of the lawn mower and

place the grass catcher frame hooks onto the door pivot pins.

To convert to mulching or discharging operation, remove grass catcher and close rear door.

Pivotpins

SIDE DISCHARGING

Rear door must be closed.

Open mulcher door and install dis- charge deflector under guard as shown.

Mower is now ready for discharging operation,

To convert to mulching or bagging

operation, discharge deflector must be removed and mulcher door must be

closed.

SIMPLE STEPS TO REMEMBER WHEN CONVERTING YOUR LAWN MOWER

FOR MULCHING-

1.Rear door closed.

2.Mulcher door closed.

FOR REAR BAGGING -

1.Grass catcher installed.

2.Mulcher door closed.

FOR SIDE DISCHARGING -

1.Rear door closed.

2.Side discharge deflector installed. _,CAUTION: Do not run your lawn mower without rear door closed or

approved grass catcher in place.

Never attempt to operate the lawn mower with the rear door removed or prepped open.

7

Image 7
Contents Jcraftsmanj General Operation Limited TWO Year Warranty on Craftsman Power MowerIII. Children IV, ServiceII. Slope Operation Do notLawn Mower Performance Lawn Mower MaintenanceTo Remove Lawn Mower from Carton Howto SET Upyour Lawn Mower To Unfold HandleTo Install Atiachments UpperKnow Your Lawn Mower Meets Cpsc Safety RequirementsMulcherdoor Convert Mower To Adjust Cutting HeightHowto Useyour Lawn Mower Engine Speed Control Engine Zone ControlADD Gasoline To Start EngineTo Stop Engine Before Starting Engine ADD OILMulching Mowingtips MowingtipsGeneral Recommendations Tion ChartMaintenance Schedule LubricationTires Lawn MowerBlade Care To Change Engine OIL EngineGrass Catcher LubricationMuffler Lawn Mower To Adjust CUI-FING HeightTo Adjust Handle CleaningHandle Lawn MowerCarburetor Cylinder Troubleshooting Chart Problem CauseEngine Fuel System Engine OILBuildup of grass, leaves Loss of power Rear of lawn mowerContact a Sears or other qualified service center Dirty air filterCraftsman Rotary Lawn Mower - Model no UpperHane Craftsman Rotary Lawn MOWER-- Model noCraftsman 4-CYCLE Engine ++++ ,7o+ 1210 689 O 332 304 363@Emissions Label L.EASKETSeT CnAFrSMA,4-CYCLE Engine 231082 Craftsman Cycle EngineGet it fixed, at your home or ours