Storage, Cleaning, Spark Plug, Muffler

WARNING: PERIODICALLY CLEAN MUF- FLER AREA TO REMOVE ALL GRASS, DIRT AND COMBUSTIBLE DEBRIS.

CLEANING

•The chipper-shredder may be cleaned by running water from a hose through the hopper assembly and chipper chute with the engine running. Allow the chipper-shredder to dry thoroughly.

•Wash the bag periodically with water. Allow to dry thoroughly in the shade. Do not use heat.

Clean Out

:haft and Dirt

FIGURE 11.

SPARK PLUG

The spark plug should be cleaned and the gap reset to .030" at least once a season or every 50 hours of

operation. See figure 12. Spark plug replacement is recommended at the start of each season. Refer to

engine parts list for correct spark plug type.

NOTE: Do not sandblast spark plug. Spark plug should be cleaned by scraping or wire brushing and washing with a commercial solvent.

.030" Feeler Gauge

Spark Plug

FIGURE 12.

MUFFLER

Do not operate the chipper-shredder without a muffler or tamper with the exhaust system. Damaged mufflers or spark arresters could create a fire hazard. Inspect periodically, and replace if necessary. If your engine is equipped with a spark arrester screen assembly, remove every 50 hours for cleaning and inspection. Replace if damaged.

STORAGE

Prepare your chipper-shredder for storage at the end of the season or if the unit will not be used for 30 days or more.

&WITH FUEL IN THE FUEL TANK INSIDE

OF BUILDING WHERE FUMES MAY REACH AN OPEN FLAME OR SPARK, OR

WHERE IGNITION SOURCES ARE PRESENT SUCH AS HOT WATER AND SPACE HEATERS, FURNACES, CLOTHES

DRYERS, STOVES, ELECTRIC MOTORS,

ETC.WARNING: NEVER STORE MACHINE

NOTE: A yearly check-up by your local Sears Service Center is a good way to make certain your chipper- shredder will provide maximum performance for the next season.

CHIPPER-SHREDDER

•Clean the chipper-shredder thoroughly.

•Wipe unit with an oiled rag to prevent rust (use a light oil or silicone).

ENGINE

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL

OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARA- TION AND FORMATION OF ACIDS DURING STOR- AGE. ACIDIC GAS CAN DAMAGE THE FUEL SYS- TEM OF AN ENGINE WHILE IN STORAGE.

•Drain the fuel tank.

•Start the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.