Craftsman 770-5875B, 247.796890 manual Fuel Tank Park Plug, Attaching the Catcher BAG

ATTACHING THE CATCHER BAG

Your unit is equipped with a nylon bag which attaches to the discharge opening. If desired, place the end of the bag over the chute deflector. Depress plunger, pull

on the drawstring, and reIease plunger to lock it in position. See figure 6

FIGURE 6.

oPERATION

GAS AND OIL FILL tJP

NOTE

ENGINE lS SHIPPED WITHOUT OIL. FILL CRANKCASE WITH OIL BEFORE STAR- TtNG BE VERY CAREFUL NOT TO ALLOW DIRT TO ENTER THE ENGINE WHEN CHECKING OR ADDING OIL OR FUEL

Recommended SAE Viscosity Grades

....................... : ii lUHl=

2Fill fuel tank. See figure 8. Use fresh, clean, unleaded automotive gasoline. Capacity is 3 quarts_

Throttle

Control Lever luffler

Fuel

Tank

• park

Plug,

and

LIII TI !o! o T9 ErrI, ,,,!r!t!r

-20 ° 0 o 32 ° 60 ° 80 ° 100 °

TEMPERATURE RANGE EXPECTED BEFORE NEXT OIL CHANGE, ALL OILS MUST A,PI SERVICE CLASSIFICA- TION SD, SE OR SE

FIGURE 8,

1, Fill engine with oil,

aRemove engine oil fillplug. See figure 7.

b.With chipper-shredder level, fill engine with oil to point of overflowing. Capacity is 1-1/4 pints

cTilt chipper-shredder forward on its wheels, then re-level.

dCheck oil level, Refill to point of over-flowing if necessary. Replace oil fill plug.

j o_ \'tll)i

Plug

tw...,.ot

Fill to within 1/2 inch of top of fuel tank to prevent spills and to allow for fuel expansion If gasoline is accidently spill-

ed, move chipper-shredder away from area of spill Avoid creating any source of

ignition until gasoline vapors have disappeared,

t

Oil Drain Plug

FIGURE 7.

NOTE

DO NOT USE GASOHOL OR METHANOL. These type fuels react with water content in the fuel and tend to form strong acids which can corrode metal parts and harm rubber plastics_

USE CLEAN OIL AND FUEL. STORE IN APPROVED, CLEANI COVERED CON+ TAINERS, USE CLEAN FILL FUNNELS.

6