Craftsman 247.77588O owner manual Chipper-Shredder, Engine, Other, Season

Page 17

Prepare your chipper-shredderforstorageat the end of the season or if the unitwillnot be used for 30 days or more.

A WARNING: Never store machinewith fuel in the fuel tank inside of building where fumes may reach an open flame or spark, or where ignitionsourcesare present such as hot water end space heaters, furnaces, clothes dryers, stoves, electricmotors,etc.

A yearly check-up by your local Sears service center is a good way to make certain your chipper-shredder will provide maximum performance for the next

season.

CHIPPER-SHREDDER

Clean the chipper-shredderthoroughly.

Wipe unitwith an oiled rag to prevent rust (use a light oil or silicone).

ENGINE

IMPORTANT; It is importantto prevent gum deposits from forming in essentialfuel system parts such as carburetor,fuel filter,fuel hose, or tank during storage. Also, experience indicatesthat alcohol blendedfuels (called gasohol or using ethanol or methanol) can attractmoisturewhich leads to separationand formationof acids duringstorage. Acidic gas can damage the fuel system of an engine while in storage.

Drain the fuel tank.

Start the engine and let it run untilthe fuel lines and carburetor are empty.

Drain carburetor by pressingupward on bowl drain which is located belowthe carburetor.

Never use engine or carburetorcleaner

products in the fuel tank or permanent damage

may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternativein

minimizing the formation of fuel gum deposits during storage.

Add stabilizerto gasoline in fuel tank or storage container.

Always follow the mix ratiofound on stabilizer container.

Run engine at least 10 minutesafter adding stabilizerto allow the stabilizerto reach the

carburetor.

Do not drain the gas tank and carburetorif using fuel stabilizer.Drain all the oilfrom the

crankcase (this shouldbe done after the engine has been operated and is stillwarm) and refill the crankcase with fresh oil.

If you have drainedthe fuel tank, protectthe inside of the engine as follows.

Remove spark plug,pour approximately 1/2 ounce (approximatelyone tablespoon) of engine oil intocylinderand crank slowlyto distributeoil. Replace spark plug.

OTHER

Do not store gasolinefrom one season to another.

Replace yourgasoline can if your can startsto rust. Rust and/or dirtin your gasolinewill cause problems. Store unit in a clean, dry area. Do not store next to corrosivematerials, such as fertilizer.

NOTE; ff storing in an unventilated or metal storage shed, be certain torustproofthe equipment by coating with a light oil or silicone.

17

Image 17
Contents Craftsman Tow HitchKit Product SpecificationEngine To cause cancer, birthdefects or other reproductiveharm General OperationImpellertocometoacompletestopTheimpeller ServiceChildren Your ResponsibilityChipperChute HopperLoose Parts Unpacking from CartonSpacer-J-Hinge Attaching Hopper AssemblyAttaching the Catcher BAG Attaching the Chipper ChuteOperating Controls Meets Ansi Safety StandardsStarting Engine GAS and OIL FILL-UPOil Packed with unit Add oil if necessary. Replace dipstickStopping Engine Using Your CHIPPER-SHREDDERTo lowerthe hopper assembly, use one handto Engine Maintenance CleaningChangesbecomesstdngy,etc. or if the rate at which General RecommendationsCustomer Responsibilities Lubrication Ifnecessary,replacepaper filterdo not attemptAvoid these areas Spark Plug MufflerPage Sharpening or Replacing Blades Removing the Flail ScreenHex Nut Washer Hand Knobs Chipper BladesAdjusting Carburetor Disconnectsparkplug wire and move it awayTires Engine SpeedEngine CHIPPER-SHREDDEROther SeasonContactyourSEARS service center Serviceaircleaner Loss of power operationerraticEnginefailstostart Fueltankempty,orstalefuelModel Sears Craftsman 8.5 H.P. CHIPPER-SHREDDERKey PartNo No 53 714-0149B 57 781-0510B 770-1228A 11480 681-0118 681-0144 710-0542757 RPM Low 21132 Carburetor ¢p-.4 Sears