Craftsman 917.38885 owner manual Mulching Mowing Tips

Page 10

MOWING TIPS

CAUTION: Do not use de-thatcher blade attachments on your mower. Such attachments are hazardous, will damage your mower and could void your warranty.

Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of grass clip- pings. It may also be necessary to re- duce ground speed and/or run the lawn mower over the area a second time.

For extremely heavy cutting, reduce the width of cut by overlapping previously cut path and mow slowly.

For better grass bagging and most cut- ting conditions, the engine speed should be set in the FAST position.

When using a rear discharge lawn mower in moist, heavy grass, clumps of cut grass may not enter the grass catcher. Reduce ground speed (pushing speed) and/or run the lawn mower over the area a second time.

If a trail of clippings is left on the right side of a rear discharge mower, mow in a clockwise direction with a small over- lap to collect the clippings on the next pass.

Pores in cloth grass catchers can be- come fi lled with dirt and dust with use and catchers will collect less grass. To prevent this, regularly hose catcher off with water and let dry before using.

Keep top of engine around starter clear and clean of grass clippings and chaff. This will help engine air fl ow and extend engine life.

MULCHING MOWING TIPS

IMPORTANT: For best performance, keep mower housing free of built-up grass and trash. See “CLEANING” in the Maintenance section of this manual.

The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this will provide the best recut- ting action of the blades.

Avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early afternoon. At this time the grass has dried, yet the newly cut area will not be exposed to direct sunlight.

For best results, adjust the lawn mower cutting height so that the lawn mower cuts off only the top one-third of the grass blades. If the lawn is overgrown it will be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of mulched grass. For extremely heavy grass, reduce your width of cut by overlapping previously cut path and mow slowly.

MAX 1/3

Certain types of grass and grass conditions may require that an area be mulched a second time to completely hide the clippings. When doing a sec- ond cut, mow across (perpendicular) to the fi rst cut path.

Change your cutting pattern from week to week. Mow north to south one week then change to east to west the next week. This will help prevent matting and graining of the lawn.

10

Image 10
Contents Rotary Lawn Mower Warranty Table of ContentsSafety Rules III. Children General OperationII. Slope Operation IV. Safe Handling of GasolineProduct Specifications General ServiceAccessories Repair Protection AgreementsHOW to SET UP Your Lawn Mower Assembly / PRE-OPERATIONTo Remove Lawn Mower from Carton Operation Meets Cpsc Safety RequirementsKnow Your Lawn Mower HOW to USE Your Lawn Mower To Stop Engine Before Starting EngineTo Start Engine Mowing Tips Mulching Mowing TipsGeneral Recommendations MaintenanceLubrication Chart Before Each USETires Lawn MowerEngine Blade CareMuffler CleaningAIR Filter Spark PlugRear Deflector Service and AdjustmentsTo Adjust Handle CarburetorHandle StorageFuel System Engine OIL Problem Cause CorrectionOther CylinderPoor cut Get it fixed, at your home or ours