Craftsman 247.775890 manual Service

Page 4

shutoff.Neverplaceanypartofthebodyinthe

impeller area until you are sure the impeller has stopped rotating.

Muffler and engine become hot and can cause a bum.

Do not touch.

Do not allow leaves or other debris to build-up on

engine'smuffler. The debds could ignite and cause a fire.

Do not attempt to shred or chip material larger than

°specified in this manual. Personal injury or damage to the machine could result.

Do not operate engine if air cleaner or cover over carburetor air-intake is removed, except for adjustment. Removal of such parts could create a tim hazard.

Only use acoessodes approved for this machine by the manufacturer. Read, understand, and follow all instructions provided with the approved accessory.

If situations occur which are not covered by this

manual, use care and good judgment. Contact your dealer for assistance.

Keep discharge chute deflector, chipper chute flap, and all other guards and safety devices in place and operating properly.

Only operate unit in good daylight. Do not operate unit at night or in dark areas where your vision may be impaired.

CHILDREN

Tragic accidents can occur if the operator is not alert to the presence of small children. Children are often attracted to the chipper-shredder and the chipping and shredding

activity. Never assume that children will remain where you last saw them.

Keep children out of the work area and under the watchful eye of a responsible adult other than the operator.

Be alert and tum the unit off if a child enters the aree.

Never allow children under the age of 16 to operate the chipper-shredder.

SERVICE

Use extreme cam in handling gasoline and other fuels. They are extremely flammable and the vapors are explosive.

a.Store fuel and oil in approved containers, away from heat and open flame, and out of the reach of children. Check and add fuel before starting the engine. Never remove gas cap or add fuel while

the engine is running. Allow engine to cool at least two minutes before refueling.

b.Replace gasoline cap securely and wipe off anl spilled gasoline before starting the engine as it may cause a fire or explosion.

c.Extinguish all cigarettes, cigars, pipes and other soumes of ignition.

d.Never refuel unit indoors because flammable vapors will accumulate in the area.

e.Never store the machine or fu_l cS"ntalnerinside where there is an open flame or spark such as a_ -....

gas hot water heater, space heater, clothes dryer or furnace.

Never run your machine in an enclosed area as the exhaust from the engine contains carbon monoxide, which is an odorless, tasteless and deadly poisonous gas.

To reduce fire hazard, keep engine and muffler free of leaves, grass, and other debds build-up. Clean up fuel and oil spillage. Allow unit to cool at least 5 minutes before storing.

Before cleaning, repaidng, or inspecting, make certain the impeller and all moving parts have stopped. Disconnect the spark plug wire and keep wire away from spark plug to prevent accidental starting. Do not use flammable solutions to clean air filter.

Check the blade and engine mounting screws at frequent intervals for proper tightness. Also visually inspect blades for wear and/or damage (e.g., bent, cracked). Replace with blades which meet original equipment specifications.

Keep all nuts, bolts, and screws tight to be sure the equipment is in safe working condition.

Never tamper with safety devices. Check their proper operation regulady.

After striking a foreign object, immediately stop the engine, disconnect the spark plug wire from the spark plug, and thoroughly inspect the unit for any damage. Repair damage before starting and operating unit.

Do not alter or tamper with the engine'sgovernor setting. The governor controls the maximum safe operating speed of the engine.. Ov_r-spmeding the engine is dangerous and will cause damage to the engine and to other moving parts of the machine.

YOUR RESPONSIBILITY

Rastdct the use of this power machine to persons who road, understand and follow the warnings and instructions In this manual and on the machine.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE

This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush.covered or grass-covered land unless the engine'sexhaust system is equipped with a spark arreeter meeting applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.

In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is evallable through your nearest Sears Authorized Service Center (See the REPAIR PARTS section of this manual.)

Image 4
Contents Horse Power Sears, Roebuck and Co., Hoffman Estates, IL 60179, U.S.AProduct Specification Generaloperation Service Disconnecting Spark Plug Remove From CartonLoose Parts Tools RequiredAttaching Hopper Assembly Attaching Chipper Chute Attaching Catcher BagOperating Controls Gas And Oil Fill-Up Using Rear Wheel Lock LeverToover u, dipsUckondUghton Using Your Chipper-Shredder Starting EngineLower the hopper to collect Cleaning Engine MaintenanceGeneral Recommendations Customer ResponsibilitiesClean Engine Givenbelow Removeoildrainplug.Catchoilina suitableLubrication Removing Flail Screen Sharpening Or Replacing BladesAdjusting Carburetor Adjusting Engine Speed Replacing Fuel FilterEngine Chipper-ShredderOther Problem Possible Cause Corrective Action Craftsman 10 H.P. Chipper Shredder Model 247,775890 Craftsman 10 H.P. Chipper Shredder Model For Chipper Shredder 19G432-1182-E1 for Chipper Shredder 142 lO5 240 138 Page Mmmmmm