Remove From Carton, Loose Parts | Craftsman 247.775890 manual

I Rear

IMPORTANT: This unit is shipped without gasoline or oil in the engine. After assembly, see OPERATION section of this manual for proper fuel and engine oil fill-up.

NOTE: To determine right and left hand sides of your chipper-shredder, stand behind the-onit with the engine farthest away from you. See Figure I inset. _

Your chipper-shredder has been completely assembled at the factory, except for the hopper assembly, chipper chute, discharge chute and the catcher bag. These parts are shipped loose in the carton. A pair of safety glasses and two bottles of oil are also included in the carton.

Remove From Carton

2Bottles of OII

Chipper

Chute

*The hopperis packed in _e top Insert In your chipper-shredder carton.

Figure I

Spark Plug Wire

Figure 2

Hopper"

Discharge Chute

:hlp Bag

•Cut the comers of the carton. Remove all packing inserts. Remove all loose parts including owner'smanual. See Figure 1,

•Roll chipper-shredder out of the carton.

•Make certain all parts and literature have been removed before the carton is discarded.

Loose Parts

(Refer to Figure 1.)

a.Hopper Assembly

b.Discharge Chute

c.Chipper Chute

d.Leaf Bag, chip bag

e.Bottle of Oil (2)

f.Safety Glasses (not shown in Figure 1)

g.Owner'sManual (not shown in Figure 1)

Tools Required

1.1/2" or adjustable wrenches

2.7/16" or,adjustable wrencbes

3.9/16 _ or adjustable _ncl_es "_

4.Funnel

Disconnecting Spark Plug

•Disconnect the spark plug wire and move it away from the spark plug before assembling the chippar-shredder. See Figure 2.

Attaching Discharge Chute

•Remove the wing knobs from each side of the discharge opening on the chipper-shredder.

•Using two 7/16" wrenches, remove hex lock nut, two spacers, and the he]( bolt from top of the housing assembly. For easy assembly, do not remove the second spacer from the hex bolt.

•Place the discharge chute in position on the discharge opening as shown in step I in Figure 3. Insert hex bolt and spacer through hinge on discharge chute and housing (spacer fits inside of hinge). See Figure 3 inset A.