Craftsman 141, 385 owner manual Muffler, AIR Filter

Page 13

÷L

Change the oil after every 25 hours of op- eration or at least once a year if the mower is not used for 25 hours in one year.

Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil plug securely each time you check the oil level.

TO CHANGE ENGINE OIL

NOTE: Before tipping lawn mower to drain oil, empty fuel tank by running engine until fuel tank is empty.

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

2.Remove engine oil cap; lay aside on a clean surface.

3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to re-

move any oil trapped inside of engine.

4.Wash element in liquid detergent and water.

5.Wrap element in cloth and squeeze dry.

6.Lightly coat filter element with clean engine oil. Squeeze in towel to remove excess oil. Do not saturate.

7.Reassemble parts and put back on carburetor.

Screw

ASSEMBLE

ONE OF THESE

LOW POINTS

_

TOWARDS

NARROW EDGE

OF ELEMENT

Lip Element Cup

ASSEMBLE SO LIP

EXTENDS OVER

EDGE OF

AIR CLEANER

BODY

LiP WILLFORM

PROTECTIVE

SEAL WHEN

COVERIS ASSEMBLED

MUFFLER

®Container

4.Wipe off any spilled oil from lawn mower or side of engine.

5.Slowly pour oil down the oil fill spout, stopping every few ounces to check the oil level with the dipstick.

6.Stop adding oil when you reach the FULL mark on the dipstick. Wait a minute to allow oil to settle.

7.Continue adding small amounts of oil, rechecking the dipstick until oil level settles at FULL. DO NOT overfill, or engine will smoke heavily from the muf- fler on startup.

8.Always be sure to retighten oil dipstick before starting engine.

9.Reconnect spark plug wire to plug.

AIR FILTER

Your engine will not run properly and may be damaged by using a dirty air filter. Clean the element after every 25 hours of operation or every season. Replace the air filter every 100 hours of operation or every season, whichever occurs first. Service air cleaner more often under dusty conditions.

TO CLEAN AIR FILTER ELEMENT

1.Remove screw.

2.Remove air cleaner carefully to prevent dirt from entering carburetor.

3.Take air cleaner apart and clean element.

Inspect and replace corroded muffler as it

 

could create a fire hazard and/or damage.

®

SPARK

PLUG

 

 

Replace spark plug at the beginning of

 

each mowing season or after every 100

 

hours of operation, whichever occurs

 

first. Spark plug type and gap setting

 

are shown in the "PRODUCT SPECIFIC-

 

ATIONS" section of this manual.

 

CLEANING

 

 

 

 

IMPORTANT:

For

best

performance,

 

keep mower housing free of built-grass

 

and trash. Clean the underside of your

 

mower

after

each

use.

 

 

ACAUTION:

Disconnect

spark plug wire

 

from spark plug and place wire where it

 

cannot come in contact with plug.

 

Clean the underside of your lawn mower by scraping to remove build-up of grass and trash.

Clean engine often to keep trash from

accumulating. A clogged engine runs hotter and shortens engine life.

Keep finished surfaces and wheels free of all gasoline, oil, etc.

We do not recommend using a garden hose to clean lawn mower unless the

electrical system, muffler, air filter and

carburetor are covered to keep water out. Water in engine can result in short-

13ened engine life.

385141-es-412842_r0indd

13

4_

2/23/2007

10:58:15AM

Image 13
Contents Rotary Your Safety is Involved Warranty Maintenance 11-13 Safety Rules ServiceSears, Roebuck and Co., Hoffman Estates, IL II. Slope Operation General OperationDo not Oil Type API SG-SL General ServiceSAE RJ19LM or J19LMLawn Mower Maintenance Product replacement if your covered product cant be fixedLawn Mower Performance To Install Attachments NOW to SET UP Your Lawn Mower To Unfold HandleTo Remove Lawn Mower from Carton MowingKnow Your Lawn Mower Meets Cpsc Safety RequirementsWithout OIL or Engine Speed To Adjust Cutting HeightEngine Zone Control To Convert MowerTo Stop Engine ADD GasolineTo stop engine, release operator pres- ence control bar To Start EngineMulching Mowing TiPS Before Each USE General RecommendationsLubrication Tires Lawn MowerAIR Filter MufflerRear Deflector To Adjust HandleDischarge Guard RotateFold FO Rwar E SqueezeFor StorageOther Poor Cut Loss PowerVibration Starter ropeSU Seguridad Esta Comprometida IV. Manejo Seguro DE Gasolina III. NinosHaoer No HaoerCapacidad De Aceite Onzas Bujia Abertura Sobre 32F SAE 5W-30 Debajo 32FRJ19LM J19LMRendimiento DE LA Segadora Acuerdo8 de Proteccion para la ReparacionMantenimiento DE LA Segadora Como Preparar SU Segadora Para Desdoblar EL Mango Para Remover LA Segadora DE LA Caja DE CartonPara Instalar LOS Aocesorios Barra de control que exige la presencia del operador Familiaricese CON SU SegadoraOord6n Arrancador Filtro de airePara Ajustar LA Altura DE Corte Como Usar SU Segadora Velooidad DEL MotorPara Convertir LA Segadora AVlSO El ajustador esta correctamentePara Hacer Arrancar EL Motor Para Parar EL MotorAntes DE Hacer Arrancar EL Agregue GasolinaConsejos Para Segar Y Acolchar Onsejos Para SegarRecomendaciones Generales Cuidado DE LA Cuohilla LlantasPara Remover LA Cuchilla Para Cambiar LA CuchillaPara Limpiar EL Filtro DE Aire Filtro DE AireLimpieza PRECAUOI6NDesviador Trasero SegadoraMotor Para Ajustar EL Mango CarburadorAceite DEL Motor MotorCjlindro Centro AervJco Sears ProblemasNo arranoa Mal corte= ProblemaCraftsman Rotary Lawn Mower - Model Number Wheel Adjusting Bracket Clip, CIoseout Lawn Mower Housing Includes Key NumberAxle Arm Assembly Rear, LH Axle Arm Assembly Front, LHModel Number 10T702=3857-EA Briggs & Stratton 4=CYCLE Engine524@ Engine Gasket SETEmissions Labeli Replacement EngineRepair Manual Breather Assembly Cylinder AssemblyScrew Breather Assembly Piston Assembly StandardKEY Part Description Inches Inch = 25.4 mmAnytime, day or night U.S.A. only A. and CanadaIiiiiiii!....!iiiiiii!ii!ii