Parts Available, Blower Storage | Craftsman 79938 manual

NOTE:Iftheunitbecomesclogged,or anobjectisdrawnintotheair intake,

stop the unit and disconnect the exten- sion cord. Wait until the impeller has completely stopped turning, then re- move the vacuum tubes. Caretuily

reach into the vacuum opening and clear out the air intake area.

Inspect the impeller for cracks. If cracked or damaged, do not use the

unit. have parts replaced by your

Sears Service Center. Do not attempt to replace them yourself,

Prepare unit for storage at the end of the season or if it will not be used for

30 days or more.

_bWARNING:

•Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury.

•Store unit well out of the reach of children.

BLOWER STORAGE

grass, or debris that has cctlected, Inspect the blower and all tubes.

Close and make sure the cover is latched.

•Clean air vents and air inlet of debris,

•Store your unit and extension cord in a well ventilated area and covered, if

possible, to prevent dust and dirt ac- cumulation, Do not cover with plastic.

Plastic cannot breathe and may cause condensation and eventual rust or corrosion.

•Check entire unit for loose screws,

•Disconnect from the power source.

•Clean the entire unit.

nuts, and bolts. Replace any darn- aged, worn, or broken parts.

•Open inlet cover and clean any dirt,

SYMPTOM	CAUSE	REMEDY
Unit fails to	. Switch in the OFF position.	=Slide switch to ON position.
operate.	• Extension Cord Disconnected	•Reconnect extension cord.
	. Circuit breaker tripped, or fuse	•Reset circuit breaker or fuse.
	blown
	• Mechanical failure	.Contact	your Sears	Service
		Center.
Unit	. Mechanical failure	•Contact	your Sears	Service
vibrates		Center
abnormally.
Impeller will	•Debris in air intake area.	•Clean	unit. Remove any
notturn	. Mechanical failure	debris.
freely.		•Contact your Sears		Service
		Center