HOWTOREMOVEANOBJECT FROMTHEAIRINTAKE
NOTE; If the unit becomes clogged, or an object is drawn into the air intake, stop the unit and disconnect the exten-
sion cord. Wait until the impeller has completely stopped turning, then re- move the vacuum tubes. Carefully reach into the vacuum opening and clear out the air intake area.
inspect the impeller for cracks. If cracked or damaged, do not use the
unit. have parts replaced by your Sears Service Center. Do not attempt to replace them yourself.
PARTS |
| AVAILABLE |
|
Blower | Tube | 534352705 | |
Vacuum |
| Tube Set | 530402499 |
inlet Restrictor | 530402045 | ||
Nozzle |
| ............... | 530402461 |
Collection | Bag | 530402533 | |
Gutter | Kit | ||
Safety | Glasses | ||
Extension | Cord |
Prepare unit for storage at the end of the season or if it will not be used for
30 days or more.
WARNING:
•Secure the unit before storing or transporting.
•Store unit with all guards in place. Position unit so that any sharp object cannot accidentally cause injury.
•Store unit well out of the reach of children.
BLOWER STORAGE
•Disconnect from the power source.
•Clean the entire unit.
•Open inlet cover and clean any dirt,
TROUBLESHOOTING CHART
grass, or debris that has collected.
Inspect the blower and all tubes. Close and make sure the cover is
latched.
•Clean air vents and air inlet of debris.
•Store your unit and extension cord in a well ventilated area and covered, if possible, to prevent dust and dirt ac-
cumulation. Do not cover with plastic.
Plastic cannot breathe and may
cause condensation and eventual rust or corrosion.
•Check entire unit for loose screws, nuts, and bolts. Replace any dam- aged, worn, or broken parts.
SYMPTOM | CAUSE |
|
|
|
| REMEDY |
|
|
| |||
Unit | fails | to | • Switch | in | the | Off | position. | • Slide switch |
| to on position. | ||
operate. |
| • Extension | Cord | Disconnected | • Reconnect | extension | cord. | |||||
|
|
| • Circuit | breaker | tripped, or fuse | • Reset | circuit |
| breaker | or fuse. | ||
|
|
| blown |
|
|
|
|
|
|
|
|
|
|
|
| • Mechanical | failure | • Contact | your | Sears | Service | ||||
|
|
|
|
|
|
|
| Center. |
|
|
|
|
Unit |
|
| • Mechanical | failure | • Contact | your | Sears | Service | ||||
vibrates |
|
|
|
|
|
| Center |
|
|
|
| |
abnormally. |
|
|
|
|
|
|
|
|
|
| ||
Impeller | will | • Debris | in | air intake area. | • Clean | unit. | Remove | any | ||||
not | turn |
| • Mechanical | failure | debris. |
|
|
|
| |||
freely. |
|
|
|
|
|
| • Contact | your | Sears | Service | ||
|
|
|
|
|
|
|
| Center |
|
|
|
|
10