:lead these instructionsand the operating manual in its entirety_beforeyou attemptto operate your new air blower.
BlowerTube Curved Nozzle Tube
Clamp (_,
ExtensionTube
Cable Guide
Clamp with
Blower | Pleated Tube |
_TO][o._]:,,,."[._o__tl[.,._
The following items for the operation of your blower are available at your nearest Sears store.
• | Safety goggles | • | Airfilter |
• | Hearing protection | • | Fuel stabilizer |
• | Gloves | • | Spark plug |
• | • | Gas can |
V-!.'%'1hVd:]lWd
Read these instructionsand the operating manual in its entirety before you attempt to assemble or operate your new backpack air blower.
Your new backpack air blower has been assembled at the factory except for the blower tubes. The necessary clamps to complete assembly as well as a combination
wrench are included in the parts bag enclosed with the unit.
To ensure safe and proper operation of your backpack air blower, any clamp that you install must be tightened securely.
HOW TO ASSEMBLE
1.The elbow tube is already inserted intothe blower housing. Insure that the two screws (Fig. 1, A) are
tight, but not so tight that the tube cannot be easily swiveled.
2.Slidethe pleatedtube (Fig. 2, E) onto the elbow (Fig. 2, B) and secure with the clamp (Fig. 2, C) that has an attached cable guide. Install throttle cable (Fig. 2, D) intothe clamp cable guide.
FIGURE 2
FIGURE 1
3,
Loosenthe two screws (Fig. 3, H) on the bottomof the attached handle clamp. Make sure that the clamp goes over the top of the raised _ on the undersideof the blower tube, and that the leg of the "T" is alignedwith the slot on the clamp. Push blower tube into the pleated tube and secure with the plasticclamp (Fig. 3, G). The
handle (Fig. 3, F) has a
4