TROUBLE-SHOOTING
PROBLEM | POSSIBLE CAUSE |
| CORRECTIVE ACTION |
|
|
|
|
Engine fails to start | 1. Blade control handle disengaged | 1. | Engage blade control handle. |
| 2. Spark plug wire disconnected | 2. Connect wire to spark plug. | |
| 3. Throttle control lever not in starting position | 3. Move throttle lever to starting position. | |
| 4. Fuel tank empty, or stale fuel | 4. Fill tank with fresh, clean fuel. | |
| 5. Blocked fuel line | 5. Clean fuel line. | |
| 6. Faulty spark plug | 6. Clean, adjust gap or replace. | |
Engine runs erratic | 1. Spark plug wire loose | 1. | Connect and tighten spark plug wire. |
| 2. Blocked fuel line or stale fuel | 2. Clean fuel line, fill tank with clean, fresh | |
|
|
| gasoline. |
| 3. Vent in gas cap plugged | 3. Clear vent. | |
| 4. Water or dirt in fuel system | 4. Drain fuel tank. Refill with fresh fuel. | |
| 5. Dirty air cleaner | 5. Clean air cleaner. Refer to | |
|
|
| Maintenance section of this manual. |
Engine overheats | 1. Engine oil level low | 1. | Fill crankcase with proper oil. |
| 2. Air flow restricted | 2. Clean lawn mower engine. | |
Occasional skip | 1. Spark plug gap too close | 1. | Adjust gap to .030 inches. |
(hesitates) at high |
|
|
|
speed |
|
|
|
Idles poorly | 1. Spark plug fouled, faulty, or gap too wide | 1. | Reset gap to .030 inches or replace |
|
|
| spark plug. |
| 2. Dirty air cleaner | 2. Clean air cleaner following instructions | |
|
|
| on page 13. |
Excessive vibration | 1. Cutting blade loose or unbalanced | 1. | Tighten blade and adapter, balance |
|
|
| blade. |
| 2. Bent cutting blade | 2. Replace blade. | |
| 3. Bent engine crankshaft | 3. Contact your SEARS Service Center. | |
Mower will not | 1. Wet grass | 1. | Wait until later to cut. |
mulch grass | 2. Excessively high grass | 2. Mow once at a high cutting height, then | |
|
|
| mow again at desired height. Make a |
|
|
| narrower cutting swath (1/2) width. Do |
|
|
| not cut off more than 1/3 of the total |
|
|
| length. |
| 3. Dull blade | 3. Sharpen or replace blade. | |
Uneven cut | 1. Wheels not in same height position | 1. | Place all four wheels in same relative |
|
|
| height position. |
| 2. Dull blade | 2. Sharpen or replace blade. | |
For repairs beyond the minor adjustments listed above, please contact your nearest SEARS Service Center.
19