STEP 13 - ATTACH BAG BOTTOM
•Insert the bag frame strap into the stitched sleeve at the front edge of the bag bottom. See fi gure 11.
BAG FRAME STRAP
STITCHED
SLEEVE
FIGURE 11
•Assemble the bag frame strap to the holes in the lower hopper tubes using two clevis pins (N) and hair cotter pins (L). See fi gure 12.
BAG FRAME STRAP
HAIR COTTER
PIN (L)
CLEVIS PIN (N)
•Fold the bag fl aps around the lower hopper tubes and attach to the bag bottom using the snaps. See fi gure 13.
SNAP | FLAP |
|
FIGURE 13
STEP 14 - ASSEMBLE SUPPORT RODS
IMPORTANT: Do not over bend the support rods during the following step. Over bending will decrease the supporting tension of the rods.
•Assemble the two hopper support rods as shown in fi gure 14. Place the ends of the rods into the holes in the upper and lower hopper tubes, fl exing the rod just enough to fi t into the holes in the tubes.
NOTE: The hopper's mesh wind screen is not shown in
figure 14 in order to better show the hopper support rods.
SUPPORT
RODS
FIGURE 12
FIGURE 14
8