Weed Eater 545186731 instruction manual Seasonal Storage, Fuel System, Engine, Other, Porting

Page 10

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans-

porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy stor-

age.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the

starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

SReplace your gasoline can if it starts to rust.

10

Image 10
Contents Manual de Instrucciones Manuel d’Instructions Unit Safety Safety RulesOperator Safety Edging SafetyTransporting and Storage Fuel SafetySpecial Notice This unit is not Adjustable wrench Hex wrench provided AssemblyTube Assembly Examine parts for damage. Do not use dam- aged partsOperation Starting a Warm Engine Stopping Your EngineStarting Your Engine Starting PositionEdging Setting the Edging DepthStarting a Flooded Engine To set the depthMaintenance To adjust idle speed Service and AdjustmentsBlade Replacement Carburetor Idle Speed AdjustmentEngine Seasonal StorageFuel System OtherTroubleshooting Table Cause Remedy Canada, contact Ligations The U.S. EnvironmentalIntermediate 125 hours Extended 300 hours