Weed Eater WET2242STA manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 22

SERVICE AND ADJUSTMENTS

TO START ENGINE WITH A WEAK BATTERY (See Fig. 23)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

 

 

FIG. 24

TERMINAL

KEPS NUT

COVER

 

HEX

 

 

 

 

BOLT

POSITIVE (RED) CABLE

NEGATIVE (BLACK) CABLE

FIG. 25

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

FIG. 23

REPLACING BATTERY (See Figs. 24 and 25)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 26)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

 

HEADLIGHT

HOOD

WIRE

CONNECTOR

 

22

FIG. 26

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model NO. WET2242STA Safety Rules Safety Rules Table of Contents Contents of Hardware Pack To Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine Mowing Tips To Start Engine See FigGeneral Recommendations MaintenanceLubrication Chart Before Each USETractor Engine Spark Plugs CleaningMuffler IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Installation Belt RemovalTo Replace Motion Drive Belt See Fig To Check and Adjust Brake See FigTo Adjust Brake To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment To Remove Wheel for Repairs See FigInterlocks and Relays To Replace Headlight BulbTo Replace Fuse To Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor Fuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number WET2242STAElectrical KEY Part Description Chassis and Enclosures 219 17670508 Screw 5479J Plug Btn Blk Drive Shaft Asm Cross Tapered PMST/20 Steering Assembly Nut Hex Jam Toplock 1/2-20 Unf Engine Seat Assembly Decals Wheels & TiresMower Lift Mower Deck Repair Parts Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation

WET2242STA specifications

The Weed Eater WET2242STA is a versatile and efficient string trimmer designed to handle a variety of lawn maintenance tasks with ease. Known for its powerful performance and user-friendly features, the WET2242STA has become a staple in many residential gardens and landscaping projects.

One of the standout features of the WET2242STA is its robust 22cc two-cycle engine, which provides ample power for tackling even the toughest overgrowth. This engine is engineered for optimal fuel efficiency, ensuring that users can work longer without the need for frequent refueling. With a dependable starting mechanism, the Weed Eater minimizes frustration, allowing users to get started on their tasks quickly.

The design of the WET2242STA includes a straight shaft, making it easier to reach under bushes and around obstacles. The longer reach is particularly advantageous for trimming tall grass and weeds in hard-to-access areas. Additionally, the dual-line bump head simplifies the process of loading new string, enabling users to spend more time working and less time dealing with equipment maintenance.

A significant technological feature of the WET2242STA is its anti-vibration system which enhances comfort during extended use. This system significantly reduces the hand fatigue typically associated with lawn care tasks, allowing users to enjoy prolonged periods of trimming without discomfort.

The trimmer also features an adjustable handle, providing users with customizable control and comfort as they work. Whether tackling small residential lawns or larger, more demanding tasks, the adjustable handle allows for a more personalized grip.

Safety is also a priority in the design of the WET2242STA. The trimmer incorporates several safety features, including a protective shield that helps keep debris at bay and a throttle lock that prevents accidental starting.

Overall, the Weed Eater WET2242STA combines power, comfort, and user-friendly design to create a reliable tool for lawn care enthusiasts. With its powerful engine, innovative features, and thoughtful design, it stands out as an excellent choice for anyone looking to maintain a well-groomed outdoor space. The WET2242STA is engineered to make lawn care simpler and more enjoyable, ensuring that users can achieve professional results with minimal effort.
Top Page Image Contents