Weed Eater 545146904, VS2000BV instruction manual Storage

Page 11

CARBURETOR IDLE SPEED ADJUSTMENT

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:

S Engine will not idle when the throttle is re- leased.

To adjust idle speed:

Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).

S Turn idle speed screw clockwise to in- crease engine speed if engine stalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed.

Idle Speed Screw

Air

Filter

Cover

If you require further assistance or are unsure about performing this procedure, contact an

authorized

service dealer or call

1--

800--

554--

6723.

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool, and secure the unit before storing or transporting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy stor-

age.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or fuel storage container. Follow the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the

starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

SReplace your gasoline can if it starts to rust.

-- 11 --

Image 11
Contents Manual de Instrucciones Manuel d’Instructions Identification of Safety Symbols Handle Fuel with CAUTION, IT is Highly Flammable Safety RulesKnow Your Unit Plan AheadStore in a dry area out of reach of children Operate Your Unit SafelyMaintain Your Unit Properly Vacuum BAG Assembly AssemblyBlower Tube Assembly HIGH-SPEED Nozzle AssemblyOutlet Latch Area Vacuum Inlet Cover HOW to Convert Unit from Vacuum USE to Blower USEShoulder Strap Adjustment Operation Fuel Requirements HOW to Stop Your EngineHOW to Start Your Engine Before Starting Engine Fueling EngineMaintenance Check Muffler Mounting Screws Clean AIR FilterReplace Spark Plug Replace Fuel FilterStorage Empty fuel tank and refill with Troubleshooting Table Cause RemedyCanada, contact Limited WarrantyStevens Creek Road NANCE, Replacement and Repair