ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenance or ac- cessing movable parts.
WARNING: If you receive your unit assembled, check each step to insure your unit is properly assembled and all fasteners are secure. Follow all safety information in the manual and on the unit.
DA standard screwdriver is required for as- sembly.
BLOWER TUBE ASSEMBLY
1.Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: Knob must be loose enough to allow blower tube to be inserted in blower outlet. Loos- en knob by turning counterclockwise.
Blower Outlet
Groove Rib
2.Secure the tube by turning the knob clock- wise.
3.Align the slots on the lower blower tube with the tabs on the upper blower tube.
Upper Blower
Tube
Lower Blower
Tube
Tab
Slot
4.Slide the lower blower tube onto the upper blower tube.
5.Turn the lower blower tube clockwise until a click is felt to secure the lower blower tube to the upper blower tube.
NOTE: When the upper and lower blower tubes are assembled together properly, the arrows on both tubes will be aligned.
6.To remove the tubes, turn the knob coun- terclockwise to loosen the tubes; remove the tubes.
HIGH-SPEED NOZZLE ASSEMBLY
When greater air speed is desired, use the
1.Align the slots on the nozzle with the tabs on the lower blower tube.
Nozzle
Lower Blower Tab
TubeSlot
2.Slide the nozzle onto the lower blower tube.
3.Turn the nozzle clockwise until a click is felt to secure the nozzle to the lower blow- er tube.
VACUUM BAG ASSEMBLY
1.Open the zipper on the vacuum bag and insert the elbow tube.
2.Push the small end of the elbow tube through the small opening in the bag.
Elbow
TubeRib
Zipper 
Opening
Small Opening
NOTE: Make sure edge of the small opening is flush against the flared area of the elbow tube, and the rib on the elbow tube is on the bottom.
3.Close the zipper on the bag. Make sure the zipper is closed completely.
4.Remove blower tubes from engine.
Rib
Groove
5.Insert the elbow tube into the blower outlet. Make sure elbow tube rib is aligned with the blower outlet groove.
6.Turn knob clockwise to secure elbow tube.
VACUUM TUBE ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or