Weed Eater WET1742STA manual Mowing Tips, To Start Engine See Fig

Page 13

OPERATION

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can at- tract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 5)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place gear shift lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke () position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke ( ) position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke () position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tem- perature.

•The attachments can also be used during the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

MOWING TIPS

•Mower should be properly leveled for best mowing per- formance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual.

•The left hand side of mower should be used for trim- ming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 7).

FIG. 7

•If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

•Always operate engine at full throttle when mow- ing to assure better mowing performance and proper discharge of material. Regulate ground speed by se- lecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model NO. WET1742STA Safety Rules Safety Rules Table of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig HOW to SET UP Your TractorCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine To Start Engine See Fig Mowing TipsLubrication Chart MaintenanceGeneral Recommendations Before Each USETractor Engine IN-LINE Fuel Filter See Fig CleaningTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Belt Installation To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig Belt RemovalTo Adjust Brake To Check and Adjust Brake See FigTo Replace Motion Drive Belt See Fig To Check BrakeTo Adjust Steering Wheel ALIGN- Ment Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigInterlocks and Relays To Replace Headlight BulbTo Replace Fuse To Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor Other StorageFuel System Engine OILTroubleshooting Points OFF Tractor - Model Number WET1742STA SchematicElectrical KEY Part Description Chassis and Enclosures 5479J Plug Btn Blk Drive Bolt Hex 7/16-20 x 4 x Gr -1.5 Thr Steering Assembly Nut Hex Jam Toplock 1/2-20 Unf Engine 170551 Control Throt /Ch Flag Seat Assembly Wheels & Tires DecalsMower Lift 159460 Mower Deck Mandrel Assembly Includes Hous Service Notes Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation

WET1742STA specifications

The Weed Eater WET1742STA is a powerful and efficient string trimmer designed to handle various landscaping tasks with ease. It features a robust 17-inch cutting width that allows users to quickly cut through grass and weeds, making yard work more efficient. This trimmer is equipped with a reliable 2-cycle 17 cc engine, providing sufficient power to tackle dense vegetation without straining.

One of the standout features of the WET1742STA is its Easy Start technology. This user-friendly innovation ensures that starting the trimmer is simple, requiring minimal effort. With just a few pulls, users can expect a smooth ignition, which is especially beneficial for those who may have difficulty starting traditional gas-powered tools. Furthermore, the trimmer's lightweight design contributes to its overall ease of use, allowing for extended periods of operation without excessive fatigue.

The WET1742STA also incorporates the latest automatic feed spool system. This feature eliminates the need for manual line advancement, ensuring a continuous flow of cutting line as it is needed. This not only saves time but also minimizes interruptions during work sessions, allowing users to maintain their momentum while trimming.

In addition to its performance capabilities, this trimmer is designed with user comfort in mind. The ergonomic handle provides a secure grip, reducing vibration and making handling more comfortable during extended use. The adjustable telescoping shaft allows users to customize the length of the trimmer to their height, ensuring optimal control and reducing strain on the back.

Durability is another key aspect of the Weed Eater WET1742STA. Its sturdy construction is designed to withstand the rigors of outdoor use, and the quality materials used in its manufacturing help it last longer than comparable models. This trimmer is also easy to maintain, with accessible components that allow users to perform regular upkeep without hassle.

Overall, the Weed Eater WET1742STA stands out as a reliable and efficient tool for both homeowners and professional landscapers. With its combination of powerful performance, advanced features, and user-friendly design, it ensures that yard maintenance tasks are completed quickly and efficiently. Whether you're tackling overgrown areas or simply maintaining your lawn, this trimmer is equipped to meet your needs with precision and ease.
Top Page Image Contents