Weed Eater WE1538B manual To Start Engine with a Weak Battery See Fig, Replacing Battery See Figs

Page 22

SERVICE AND ADJUSTMENTS

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

WASHERS

RETAINING RING

AXLE COVER

SQUARE KEY (REAR

WHEEL ONLY)

FIG. 23

TO START ENGINE WITH A WEAK BATTERY (See Fig. 24)

WARNING: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the CUSTOMER RESPON- SIBILITIES section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

REPLACING BATTERY (See Figs. 25 and 26)

CAUTION: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

SEAT PAN

FIG. 25

KEPS

TERMINALNUT

COVER

HEX

BOLT

POSITIVE

NEGATIVE

(RED) CABLE

(BLACK) CABLE

 

FIG. 26

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

FIG. 24

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Model NO. WE1538B General Operation Safety RulesIV. Service II. Slope OperationSafety Rules Safe Operation Practices for Ride-On MowersTable of Contents Unassembled Parts Steering Wheel SeatHOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonInstall Seat See Fig Lower seat into operating position and sit on seatCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other ATTACH- Ments Before Starting the EngineTo Operate on Hills To Transport Check Engine OIL LevelMowing Tips To Start Engine See FigCustomer Responsibilities Lubrication ChartService Dates General RecommendationsTires TractorBrake Operation Operator Presence SystemBelts BatteryEngine Transaxle CoolingTo Service Cartridge Clean AIR ScreenTo Service PRE-CLEANER Engine Cooling Fins See FigSpark Plugs CleaningMuffler IN-LINE Fuel Filter See FigTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig To Replace Mower Blade Drive Belt See Fig To Level Mower HousingBelt Installation Belt RemovalTo Adjust Steering Wheel Alignment To Adjust Brake See FigFront Wheel TOE-IN/CAMBER To Attach Jumper Cables To Start Engine with a Weak Battery See FigReplacing Battery See Figs To Remove CABLES, Reverse OrderInterlocks and Relays To Adjust CarburetorTo Replace Headlight Bulb To Replace FuseFuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number WE1538BElectrical KEY Part Description Chassis Repair Parts Drive KEY Part NO. NO. Description Steering 140044X428 Optional Equipment Spark Arrester170551 Control Th/ch Flag Seat LSB42 DecalsWheels & Tires LBD48Mower Lift 159460 Wire Asm Inner/Sprg w/plunger Mower Deck Repair Parts Service Notes Limited Warranty Policy Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX

WE1538B specifications

The Weed Eater WE1538B is a versatile and reliable string trimmer designed for both residential and commercial gardening needs. This gas-powered tool combines power, efficiency, and ease of use, making it an excellent choice for homeowners and landscaping professionals alike. Engineered for optimal performance, the WE1538B features a robust 38cc engine, providing enough power to tackle tough weeds and thick grass with remarkable efficiency.

One of the standout features of this trimmer is its lightweight design, which significantly enhances maneuverability. Weighing in at just 12 pounds, the WE1538B allows users to operate it for extended periods without experiencing fatigue. The well-balanced construction ensures that users can easily handle the trimmer in hard-to-reach areas, making it an ideal tool for edging along fences or flower beds.

The WE1538B also incorporates a user-friendly starting system, which includes a manual choke to manage fuel flow, making starting the engine a straightforward process. This is particularly beneficial for novice users who may find traditional starting methods challenging. Additionally, the trimmer comes with an adjustable throttle control, allowing users to regulate engine speed according to their trimming needs.

Another notable aspect of the Weed Eater WE1538B is its dual-line cutting head. The trimmer is designed to accommodate various line sizes and types, depending on user preferences and the nature of the tasks at hand. The dual-line system helps increase cutting efficiency, allowing for a wider path and quicker trimming, reducing the amount of time spent on yard maintenance.

Moreover, the WE1538B utilizes an innovative anti-vibration technology. This feature minimizes vibrations transmitted to the user's hands, helping to reduce fatigue and discomfort during prolonged use. This technology significantly enhances user experience by allowing for longer operating times while maintaining comfort and control.

With its durable construction and essential features, the Weed Eater WE1538B is an excellent investment for anyone looking to achieve a well-maintained yard. Its combination of power, lightweight design, and user-friendly features makes it a standout choice in the string trimmer market. Whether you are battling overgrown areas or maintaining regular landscaping, the WE1538B's performance and reliability will help you achieve professional-looking results with ease.
Top Page Image Contents