Weed Eater 530163734 Installing Trimmer ATTACH- Ment, Attaching Shield, Adjusting the Handle

Page 7

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

Examine parts for damage. Do not use dam- aged parts.

NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the empty fuel tank.

Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

INSTALLING TRIMMER ATTACH- MENT

CAUTION: When installing trimmer attach-

ment, place the unit on a flat surface for stabil- ity.

1.Loosen the coupler by turning the knob counterclockwise.

Coupler

LOOSEN

WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole.

For optional attachments, see the AS- SEMBLY section of the applicable attach- ment instruction manual.

ATTACHING SHIELD

WARNING: The shield must be prop- erly installed. The shield provides partial protec- tion from the risk of thrown objects to the opera- tor and others and is equipped with a line limiter blade which cuts excess line to the proper length. The line limiter blade (on underside of shield) is sharp and can cut you. For proper orientation of shield, see KNOW YOUR TRIM- MER illustration in OPERATION section.

1.	Remove wing nut from shield.
2.	Insert bracket into slot as shown.
3.	Pivot shield until bolt passes through hole
	in bracket.

Shipping protector

TIGHTEN

Knob

4. Securely tighten wing nut onto bolt.

ShieldSlot Bracket

2.Remove shipping protector from coupler.

3.Remove the tube cap from the trimmer at- tachment (if present).

4.Position locking/release button of attach- ment into guide recess of coupler.

5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.

6.Before using the unit, tighten the knob se- curely by turning clockwise.

	Coupler	Primary Hole
			Guide Recess
	Upper	Locking/	Lower
	Upper	Release	Lower
	Tube	Release	Attachment
		Button

Wing

Nut

ADJUSTING THE HANDLE

WARNING: When adjusting the han- dle, be sure it remains between the trigger and the arrow on the safety label.

1.Loosen wing nut on handle.

2.Rotate the handle on the tube to an up- right position; retighten wing nut.

7

Image 7

Contents Manual de Instrucciones Manuel d’Instructions 1000E Operator SafetyTransporting and Storage Unit / Maintenance SafetyFuel Safety Line Trimmer SafetyBLOWER/VACUUM Safety Edger SafetyBrushcutter Safety Hedge Trimmer Safety Pole Pruner Safety Cultivator SafetyOr broken Snow Thrower SafetyAdjusting the Handle Installing Trimmer ATTACH- MentAttaching Shield Primer Bulb ON/OFF Switch ChokeHOW to Stop Your Unit Know Your TrimmerStarting a Warm Engine HOW to Start Your UnitStarting a Flooded Engine Operating the Coupler Trimmer Line Advance Installing Optional Attach MentsOperating Position RightWrong Cutting MethodsCheck for Loose Fasteners and Parts Inspect and Clean Unit and LabelsClean AIR Filter Line ReplacementFuel System Installing Spool with LineCarburetor Adjustment Seasonal StorageEngine Troubleshooting Table Cause RemedyOther Electrolux Home PRODUCTS, INC