(rear wheel only)
Mower housing
Shoulder bolt
Wheel Locknut
ASSEMBLE DISCHARGE GUARD
1.Place discharge guard on top of lawn mower discharge opening.
2.Install two (2)
3.Install two (2) 3/4" diameter washers and two (2)
Locknut.=
Washers
ASSEMBLE ENGINE ZONE CONTROL CABLE TO ENGINE
Cable attaches under brake arm cover, (opposite side of engine as spark plug).
1.Straighten cable and find the end with the small plastic fitting.
2.Hook "Z" bend fitting on inner wire of cable into hole in brake arm of engine.
3.Align tapered end of small plastic fitting with hole in mounting bracket and push until fitting snaps into place.
bracket
Small plastic Brake
fittingarm
ASSEMBLE ENGINE ZONE CONTROL CABLE TO UPPER HANDLE
Attach cable opposite upstop bracket.
1. Route cable below crossbar of lower
handle and up to control bar.
2. Hook "Z" bend fitting on inner wire into hole in control bar.
3. Attach cable fitting to upper handle.
Discharge guard
4. Secure cable to lower handle with wire tie.
Upper
bracket
bar
Hex
INSTALL CONTROL BAR
1.Position control bar so flattened section with hole is on opposite side of handle as
2.Insert one end of control bar into handle hole on inside of handle.
Carefully push in on opposite end of control bar and insert into hole on
opposite side of handle.
zone
control cable
INSTALL STARTER ROPE
1.Put threaded end of rope guide
through hole in side of upper handle above lower handle crossbar. Secure with
2.Hold control bar against upper handle and slowly pull engine starter rope out until it will slip into loop of rope guide.
Upper
Rope
|
| Engine |
,p bracket | 7 | starter rope |