Sears 917.38713 owner manual To Remove Lawn Mower from Carton, Howto SET Upyour Lawn Mower

Page 6

ASSEMBLY

Read these instructions and this manual in its entirety

before you attempt to assemble or operate your new lawn mower_ Your'new lawn mower has been assembled at the

factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc. necessary to complete the assembly have been placed in the parts bag. To ensure safe and proper operation of your'lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness

TO REMOVE LAWN MOWER FROM CARTON

°Remove loose parts included with mower

Cut down two end corners of carton and lay end panel down flat.

Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle.

Roll lawn mower'out of carton and check carton thor- oughly for additional loose part&

HOWTO SET UPYOUR LAWN MOWER

TO UNFOLD HANDLE (See Fig. 1)

IMPORTANT: UNFOLD HANDLES CAREFULLY SO AS NOT TO PINCH OR DAMAGE CONTROL CABLES

°Raise handles until lower handle section locks into place in mowing position.

. Raise upper handle section into place on lower handle,

remove protective padding and tighten both handle knobs

Remove handle padding holding operator'presence control bar to upper handle.

Your lawn mower handle can be adjusted for your mowing comforL Refer to "Adjust Handle" in the Service and Adjustment section of this rnanual.

OPERATOR PRESENCE

CONTROLBAR

UPPER HANDLE

LIFT UP

MOWING POSITION

LOWER HANDLE

FIG. 1

TO INSTALL A'I-rACHMENTS

(See Fig. 2)

Your lawn mower was shipped ready to be used as a mulcher, To convert to bagging or discharging:

=Open rear door and remove mulcher plug. Store mulcher plug in a safe piace.

You can now install catcher or optional clipping deflec- tor.

oTo return to mulching operation, install mulcher plug into discharge opening of mower.

FIG. 2

CAUTION: Do not run your lawn mower without mulcher plug in place or ap- proved clipping deflector or grass

catcher in place, Never attempt to op- erate the lawn mower with the rear'door

removed or propped open,

6

Image 6
Contents Model Number 917.387130 Ownersmanual Training Maintenance and StorageSafety is Involved Preparation Maintenance Agreement Customer ResponsibiutiesIndex Stabilizer Lawn Mower MaintenanceLAWN.MOWER Performance GAS CansHowto SET Upyour Lawn Mower To Remove Lawn Mower from CartonTo Unfold Handle See Fig To Assemble and Attach Grass LowerMeets Cpsc Safety Requirements Know Your Lawn MowerGAS See Fig Before Starting EngineOIL See Fig Engine Zone ControlTo Start Engine Mowing TiPSAS YOU Complete General Recommendations% .£,Y Before Each USELawn Mower Cleaning MufflerSpark Plug Engine Rear DeflectorLOW Handle See Fig EngineOther Engine OILRepaurparts Craftsman 20 Rotary Lawn Mower - Model noCraftsman 20 Rotary Lawn Mower - Model no KEY Part DescriptionCraftsman 4=CYCLE Engune Part DescriptionMCR Craftsman &CYCLE Engine Part DescriptionCause CorrectionIf YOU Need Repair Service Or PartsFor Repair SERVICE, Call this Toll Free Number Part Number Part Description